Heinner HPAC-12WH User manual

PORTABLE AIR CONDITIONER
Model: HPAC-12WH
www.heinner.com
Portable air conditioner
Capacity: 11600BTU
Color: white

www.heinner.com 11600BTU, 220-240V~50Hz
1
Thank you for chosing this product!
Please read this instruction manual carefully before using it and kee it for later information
This manual is conceived for ofering you all of the necessary info regarding instalation, using
and maintenance of the machine. For a correctly and safely use of the machine, please, read
this manual before instalation and using.
I. INTRODUCTION
II. PACKAGE CONTENTS
Portable air conditioner
Instruction Manual
Warranty card
Remote controller manual
Installation kit

www.heinner.com 11600BTU, 220-240V~50Hz
2
III. SAFETY PRECAUTIONS
This appliance can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning use of the appliance in a
safe way and understand the hazards involved. Children shall not play the appliance.
Cleaning and user maintenance shall not be made by children without supervision. (Be
applicable for the European Countries).
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety. (Be applicable for other countries except the
European Countries).
Children should be supervised to ensure that they do not play with the appliance. If the
supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
The appliance shall be installed in accordance with national wiring regulations.
Do not operate your air conditioner in a wet room such as a bathroom or laundry room.
The appliance with electric heater shall have at least 1 meter space to the combustible
materials.
Contact the authorised service technician for repair or maintenance of this unit.
Contact the authorised installer for installation of this unit.
When there are wide differences between USER S MANUAL and Remote controller
Illustration on function description, the description on USER S MANUAL shall prevail. If
the air conditioner is knocked over during use, turn off the unit and unplug it from the
main power supply immediately. Visually inspect the unit to ensure there is no damage.
If you suspect the unit has been damaged, contact a technician or customer service for
assistance.
In a thunderstorm, the power must be cut off to avoid damage to the machine due to
lightning.
To reduce the risk of fire or electric shock, do not use this fan with any solid-state speed
control device.
Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar
coverings. Do not route cord under furniture or appliances. Arrange cord away from
traffic area and where it will not be tripped over.

www.heinner.com 11600BTU, 220-240V~50Hz
3
.
IV. SAFETY RULES
To prevent injury to the user or other people and property damage, the following
instructions must be followed. Incorrect operation due to ignoring of instructions may
cause harm or damage.
ALWAYS DO THIS
Your air conditioner should be used in such a way that it is protected from moisture. e.g.
condensation, splashed water, etc.Do not place or store your air conditioner where it can
fall or be pulled into water or any other liquid.Unplug immediately if it occurs.
Always transport your air conditioner in a vertical position and stand on a stable, level
surface during use.
Turn off the product when not in use.
Always contact a qualified person to carry out repairs. If the damaged power supply cord
must be replaced with a new power supply cord obtained from the product
manufacturer and not repaired.
Keep an air path of at least 30cm all around the unit from walls, furniture and curtains.
If the air conditioner is knocked over during use, turn off the unit and unplug from the
mains supply immediately.
Always use the switch on the control panel.
NEVER DO THIS
Do not operate your air conditioner in a wet room such as a bathroom or laundry room.
Do not touch the unit with wet or damp hands or when barefoot.
Do not press the buttons on the control panel with anything other than your fingers.
Do not remove any fixed covers. Never use this appliance if it is not working properly, or
if it has been dropped or damaged.
Never use the plug to start and stop the unit.
Do not cover or obstruct the inlet or outlet grilles. Do not use hazardous chemicals to
clean or come into contact with the unit. Do not use the unit in the
presence of inflammable substances or vapour such as alcohol, insecticides, petrol,etc.
Do not allow children to operate the unit unsupervised.
Do not use this product for functions other than those described in this instruction
manual.
When using this air conditioner in the European countries, the following informa- tion
must be followed:
DISPOSAL: Do not dispose this product as unsorted municipal waste. Collection of such
waste separately for special treatment is necessary.
It is prohibited to dispose of this appliance in domestic household waste. For disposal, there
are several possibilities:
A) The municipality has established collection systems, where electronic waste can be
disposed of at least free of charge to the user.
B) When buying a new product, the retailer will take back the old product at least free of
charge.
C) The manufacture will take back the old appliance for disposal at least free of charge to
the user.
D) As old products contain valuable resources, they can be sold to scrap metal dealers.

www.heinner.com 11600BTU, 220-240V~50Hz
4
ENERGY SAVE
Use the unit in the recommended room size.
Locate the unit where furniture cannot obstruct the air flow. Keep blinds/curtains closed
during the sunniest part of the day. Keep the filters clean.
Keep doors and windows closed to keep cool air in and warm air out (cooling mode) or
keep warm air in and cool air out(heating mode).
OPERATING CONDITIONS
The air conditioner must be operated within the temperature range indicated below:
MODE
ROOM TEMPERATURE
COOL
17°C(62°F)~35°C(95°F)
DRY
13°C(55°F)~35°C(95°F)
HEAT(heat pump type)
5°C(41°F)~30°C(86°F)
HEAT(electrical heat type)
<30°C/86°F
Suggested tools for window kit installation
1. Screwdriver (medium size Phillips)
2. Tap measure or ruler
3. Knife or scissors
4. Saw (in the event that the window kit needs to be cut down in size because the
window is too narrow for direct installation)

www.heinner.com 11600BTU, 220-240V~50Hz
5
Be sure the electrical service is adequate for the model you have chosen. This
information can be found on the serial plate, which is located on the side of the cabinet
and behind the grille.
Be sure the air conditioner is properly grounded. To minimize shock and fire hazards,
proper grounding is important. The power cord is equipped with a three-prong
grounding plug for protection against shock hazards.
Your air conditioner must be used in a properly grounded wall receptacle. If the wall
receptacle you intend to use is not adequately grounded or protected by a time delay
fuse or circuit breaker, have a qualified electrician install the proper receptacle.
Enusre the receptacle is accessible after the unit installation.
ACCESSORIES
PARTS
PARTS NAME
QUANTITY
Exhaust hose(supplied), adapter B(round
mouth or flat month:depending on
models) and Window Slider Kit and bolt
x
1 set
Adaptor B (round mouth)x
1 set
Wall exhaust adaptorx
1 pc
Expansion plug and wooden screwx
4 pcs
Faom sealx
3 pcs
Remote Controller and Battery (For
remote control models only)
1 set
Drain hose
1 pc
Note: Optional parts *, some models without
Check all the accessories are included in the package and please refer to the installation
instructions for their usage.
VI. ELECTRICAL INFORMATION

www.heinner.com 11600BTU, 220-240V~50Hz
6
Name of the parts
Front
Rear
VII. PRODUCT DESCRIPTION
1. Operation panel
2. Horizontal louver blade (swing automatically)
3. Caster
4. Carrying handle (both sides)
5. Upper air filter (behind the grille)
6. Upper air intake
7. Air outlet
8. Drain outlet (only for pump heating model)
9. Power cord outlet
10. Power cord buckle (Used only when
storing the unit)
11. Bottom tray drain outlet
12. Power plug socket (use only when storing
the unit)
13. Lower air filter (behind the grille)
14. Lower air intake
15. Drain outlet

www.heinner.com 11600BTU, 220-240V~50Hz
7
ELECTRONIC CONTROL OPERATING INSTRUCTIONS
Before you begin, thoroughly familiarize yourself with the control panel and remote
controller and all its functions, then follow the symbol for the functions you desire.
The unit can be controlled by the unit control panel alone or with the remote
controller. NOTE: This manual does not include Remote Controller Operations, see the
<<Remote Controller Instruction>> packed with the unit for details.
OPERATION PANEL OF THE AIR CONDITIONER
NOTE: On some models SLEEP button is instead of ECO button.
1. POWER button
Power switch ON / OFF.
2. SLEEP / ECO button
Used to initiate the SLEEP/ECO operation.
3. FAN / ION button (ION is optional and available only for some units)
Control the fan speed. Press to select the fan speed in four steps-LOW, MED, HI and
AUTO. The fan speed indicator light illuminates under different fan settings except AUTO
speed. When select AUTO fan speed, all the fan indicator lights.
4. UP (+) and DOWN (-) button
Used to adjust (increasing/decreasing) temperature settings in 1˚C/2˚F (sau 1˚F)
increments in a range of 17˚C/62˚F - 30˚C/88˚F (or 86˚F) or the TIMER setting in a range of
0`24hr. NOTE: The control is capable of displaying temperature in degrees Fahrenheit or
degrees Celsius. To convert from one to the other, press and hold the Up and Down
buttons at the same time, for 3 seconds.
5. MODE sellect button
Selects the appropriate operating mode. Each time you press the button, a mode is
selected in a sequence that goes from AUTO, COOL, DRY, FAN and HEAT (cooling only
models without). The mode indicator light illuminates under the different mode settings.
VII. USING THE APPLIANCE
Ion is optional

www.heinner.com 11600BTU, 220-240V~50Hz
8
6. TIMER button
Used to intiate the AUTO ON start time and AUTO SHUT OFF stop time program in
conjunction indicator light illuminates under the timer on/off settings.
7. SWING button
Used to initiate the Auto swing feature. When the operation is ON, press the SWING
button can stop the louver at the desired angle.
8. LED display
Shows the set temperature in „˚C” or „˚F”(„˚F” no display and the Auto-timer settings.
While on DRY and FAN modes, it shows the room temperature.
10. POWER MANAGEMENT function
When the ambient temperature is lower (Cooling mode) or higher (Heating mode) than
the setting temperature for a period of time, the unit will
be automatically operate power management feature. The compressor and fan motor
stop and the power management indicator light illuminates. When the ambient
temperature is higher (Cooling mode) or lower (Heating mode) than the setting
temperature, the unit will be automatically quit the power management feature. The
power management indicator light turns dark and the compressor and (or) fan motor run.
Error codes and protection code:
E1 - Room temperature sensor error- Unplug the unit and plug it back in. If erro repeats,
call for service.
E2 –Evaporator temperature sensor error- Unplug the unit and plug it back in. If error
repeats, call for service.
E3 - Condenser temperature sensor error- Unplug the unit and plug it back in. If error
repeats, call for service.
E4 - Display panel communication error- Unplug the unit and plug it back in. If error
repeats, call for service.
P1 - Bottom tray is full - Connect the drain hose and drain the collected water away. If
protection repeats, call for service.

www.heinner.com 11600BTU, 220-240V~50Hz
9
VIII. OPERATING THE APPLAINCE
COOL OPERATION
Press the "MODE" button until the "COOL" indicator light comes on.
Press the ADJUST buttons "+" or " - " to select your desired room temperature. The
temperature can be set within a range of 17˚C-30˚C/62˚F-88˚F (or 86˚F).
Press the "FAN SPEED" button to choose the fan speed.
HEAT MODE
Press the "MODE" button until the "HEAT" indicator light comes on. Press the ADJUST
buttons "+" or “- “to select your desired room temperature. The temperature can be
set within a range of 17˚C-30˚C/62˚F-88˚F (or 86˚F). Press the "FAN SPEED" button to
choose the fan speed. For some models, the fan speed cannot be adjusted under HEAT
mode.
DRY MODE
Press the "MODE" button until the "DRY" indicator light comes on. Under this mode,
you cannot select a fan speed or adjust the temperature. The fan motor operates at
LOW speed. Keep windows and doors closed for the best dehumidifying effect. Do not
put the duct to window.
AUTO MODE
When you set the air conditioner in AUTO mode, it will automatically select cooling,
heating(cooling only models without), or fan only operation depending on what
temperature you have selected and the room temperature.
The air conditioner will control room temperature automatically round the
temperature point set by you.
Under AUTO mode, you can not select the fan speed.
NOTE: Under AUTO mode, both the AUTO mode and the actual operation mode
indicator lights illuminate.
FAN OPERATION
Press the "MODE" button until the "FAN " indicator light comes on. Press the "FAN
SPEED" button to choose the fan speed. The temperature cannot be adjusted.
Do not put the duct to window.