Henny Penny BW-4 Installation manual

Model BW-1/BW-4/BW-4/3/BW-6/BW-8
Due to the lower temperature settings, this unit has been de
signed to hold NON-POTENTIALLY HAZARDOUS FOOD
ONLY. This unit will NOT hold potentially hazardous food at
a safe temperature
1. Turn power switch to the ON position.
2. After a sequence of codes the display shows the time
of day, or “ON”.
Press and hold the TEMP button to view the actual
temperature of the unit.
Temperature Setpoint Programming
1. Press and hold the TEMP button for 6 seconds. The actual
temperature shows first followed by the flashing setpoint
temperature.
2. While holding in on the TEMP button, press and release
the SET button. Now the setpoint temperature blinks at a
faster rate. Now release the TEMP button.
3. Press the UP and DOWN buttons to change the setpoint
temperature.
4. Once the desired setpoint temperature (preprogrammed
maximum temperature) is reached, press the SET button to
return to normal operation mode and the setpoint is saved.
“Time of Day” Programming
Press and hold the SET button while using the UP and DO
buttons to set the desired time. When the SET button is re
leased, the time is saved.
SPECIAL PROGRAMMING 1. With POWER switch off, press and hold both the UP and
DOWN buttons, and then turn the POWER switch on until “SP”
shows on the display. Release the UP and DOWN buttons, and
“
oF” or “oC” shows on the display.
2. Press the UP or DOWN buttons to toggle from “oF” to “oC”,
or “oC” (Celsius) to “oF” (Fahrenheit).
OPERATING AND
PROGRAMMING
INSTRUCTIONS
306 2

Model BW-1/BW-4/BW-4/3/BW-6/BW-8
SPECIAL PROGRAMMING
(Continued) 3. Press the SET button, and “CAL” shows in the display. Press
and hold TEMP button, and press the UP and DOWN buttons to
match the display with the actual temperature.
4. Press the SET button, and “CPU” shows in the display. Press
and hold TEMP button to view the CPU (control PCB)
temperature.
5. Press the SET button, and “OutPutS” shows in the display. Press
the TEMPbutton to turn the relays, display and heaters, OFF and
ON.
6. Press the SET button, and “In-” shows in the display. Press and
hold either the UP or DOWN button until “In- SYS” shows in
the display. This programs factory settings back into the
controls.
7. Press the SET button. If “C=y” shows in the display, the time of
day shows in the display during normal operation. If “C=n”
shows in the display, “ON” shows in the display during normal
operation. Press the UP and DOWN buttons to toggle from one
to the other.
CLEANING INSTRUCTIONS 1. Turn the unit to the OFF position.
2. Disconnect electrical supply to the unit.
To avoid burns, allow the unit to cool before cleaning.
3. Open doors and wipe down racks.
4. Clean doors with a non-abrasive, soft cloth and mild soap.
Do not use ammonia.
Do not use steel wool, other abrasive cleaners or
cleaners/sanitizers containing chlorine, bromine, iodine
or ammonia chemicals, as these will deteriorate the
stainless steel material and shorten the life of the unit.
Do not spray the unit with water, such as with a garden
hose. Failure to follow this caution could cause component
failure.
5. Clean the interior and exterior of the unit with a soft cloth,
soap, and water.
3611