HIK VISION Door Station User manual

Door Staon
Quick Start Guide

Legal Informaon
Quick Start Guide
©2019 Hangzhou Hikvision Digital Technology Co., Ltd.
About this Manual
This Manual is subject to domesc and internaonal copyright protecon.
Hangzhou Hikvision Digital Technology Co., Ltd. ("Hikvision") reserves all
rights to this manual. This manual cannot be reproduced, changed,
translated, or distributed, parally or wholly, by any means, without the
prior wrien permission of Hikvision.
Please use this user manual under the guidance of professionals.
Trademarks
and other Hikvision marks are the property of
Hikvision and are registered trademarks or the subject of applicaons for
the same by Hikvision and/or its aliates. Other trademarks menoned in
this manual are the properes of their respecve owners. No right of license
is given to use such trademarks without express permission.
Disclaimer
TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, HIKVISION
MAKES NO WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WITHOUT
LIMITATION THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS
FOR A PARTICULAR PURPOSE, REGARDING THIS MANUAL. HIKVISION DOES
NOT WARRANT, GUARANTEE, OR MAKE ANY REPRESENTATIONS REGARDING
THE USE OF THE MANUAL, OR THE CORRECTNESS, ACCURACY, OR
RELIABILITY OF INFORMATION CONTAINED HEREIN. YOUR USE OF THIS
MANUAL AND ANY RELIANCE ON THIS MANUAL SHALL BE WHOLLY AT YOUR
OWN RISK AND RESPONSIBILITY.
REGARDING TO THE PRODUCT WITH INTERNET ACCESS, THE USE OF
PRODUCT SHALL BE WHOLLY AT YOUR OWN RISKS. HIKVISION SHALL NOT
Door Staon Quick Start Guide
i

TAKE ANY RESPONSIBILITIES FOR ABNORMAL OPERATION, PRIVACY
LEAKAGE OR OTHER DAMAGES RESULTING FROM CYBER ATTACK, HACKER
ATTACK, VIRUS INSPECTION, OR OTHER INTERNET SECURITY RISKS;
HOWEVER, HIKVISION WILL PROVIDE TIMELY TECHNICAL SUPPORT IF
REQUIRED.
SURVEILLANCE LAWS VARY BY JURISDICTION. PLEASE CHECK ALL RELEVANT
LAWS IN YOUR JURISDICTION BEFORE USING THIS PRODUCT IN ORDER TO
ENSURE THAT YOUR USE CONFORMS THE APPLICABLE LAW. HIKVISION
SHALL NOT BE LIABLE IN THE EVENT THAT THIS PRODUCT IS USED WITH
ILLEGITIMATE PURPOSES.
IN THE EVENT OF ANY CONFLICTS BETWEEN THIS MANUAL AND THE
APPLICABLE LAW, THE LATER PREVAILS.
Door Staon Quick Start Guide
ii

Regulatory Informaon
FCC Informaon
Please take aenon that changes or modicaon not expressly approved
by the party responsible for compliance could void the user’s authority to
operate the equipment.
FCC compliance: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protecon against harmful
interference in a residenal installaon. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instrucons, may cause harmful interference to radio
communicaons. However, there is no guarantee that interference will not
occur in a parcular installaon. If this equipment does cause harmful
interference to radio or television recepon, which can be determined by
turning the equipment o and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separaon between the equipment and receiver.
—Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help
FCC Condions
This device complies with part 15 of the FCC Rules. Operaon is subject to
the following two condions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference
that may cause undesired operaon.
Door Staon Quick Start Guide
iii

EU Conformity Statement
This product and - if applicable - the supplied accessories too are
marked with "CE" and comply therefore with the applicable
harmonized European standards listed under the EMC Direcve
2014/30/EU, the RoHS Direcve 2011/65/EU
2012/19/EU (WEEE direcve): Products marked with this symbol
cannot be disposed of as unsorted municipal waste in the
European Union. For proper recycling, return this product to your
local supplier upon the purchase of equivalent new equipment, or
dispose of it at designated collecon points. For more informaon
see: www.recyclethis.info
2006/66/EC (baery direcve): This product contains a baery
that cannot be disposed of as unsorted municipal waste in the
European Union. See the product documentaon for specic
baery informaon. The baery is marked with this symbol,
which may include leering to indicate cadmium (Cd), lead (Pb),
or mercury (Hg). For proper recycling, return the baery to your
supplier or to a designated collecon point. For more informaon
see:www.recyclethis.info
Industry Canada ICES-003 Compliance
This device meets the CAN ICES-3 (B)/NMB-3(B) standards requirements.
Door Staon Quick Start Guide
iv

Symbol Convenons
The symbols that may be found in this document are dened as follows.
Symbol Descripon
Danger Indicates a hazardous situaon which, if not avoided, will or
could result in death or serious injury.
Cauon Indicates a potenally hazardous situaon which, if not
avoided, could result in equipment damage, data loss,
performance degradaon, or unexpected results.
Note Provides addional informaon to emphasize or
supplement important points of the main text.
Door Staon Quick Start Guide
v

Safety Instrucon
Warning
•The working temperature of the device is from -10 ºC to 55 ºC.
•All the electronic operaon should be strictly compliance with the electrical
safety regulaons, re prevenon regulaons and other related regulaons in
your local region.
•Please use the power adapter, which is provided by normal company. The power
consumpon cannot be less than the required value.
•Do not connect several devices to one power adapter as adapter overload may
cause over-heat or re hazard.
•Please make sure that the power has been disconnected before you wire, install
or dismantle the device.
•When the product is installed on wall or ceiling, the device shall be rmly xed.
•If smoke, odors or noise rise from the device, turn o the power at once and
unplug the power cable, and then please contact the service center.
•If the product does not work properly, please contact your dealer or the nearest
service center. Never aempt to disassemble the device yourself. (We shall not
assume any responsibility for problems caused by unauthorized repair or
maintenance.)
Cauon
•Do not drop the device or subject it to physical shock, and do not expose it to
high electromagnesm radiaon. Avoid the equipment installaon on vibraons
surface or places subject to shock (ignorance can cause equipment damage).
•Do not place the device in extremely hot (refer to the specicaon of the device
for the detailed operang temperature), cold, dusty or damp locaons, and do
not expose it to high electromagnec radiaon.
•The device cover for indoor use shall be kept from rain and moisture.
•Exposing the equipment to direct sun light, low venlaon or heat source such
as heater or radiator is forbidden (ignorance can cause re danger).
•Do not aim the device at the sun or extra bright places. A blooming or smear
may occur otherwise (which is not a malfuncon however), and aecng the
endurance of sensor at the same me.
Door Staon Quick Start Guide
vi

•Please use the provided glove when open up the device cover, avoid direct
contact with the device cover, because the acidic sweat of the ngers may erode
the surface coang of the device cover.
•Please use a so and dry cloth when clean inside and outside surfaces of the
device cover, do not use alkaline detergents.
•Please keep all wrappers aer unpack them for future use. In case of any failure
occurred, you need to return the device to the factory with the original wrapper.
Transportaon without the original wrapper may result in damage on the device
and lead to addional costs.
•Improper use or replacement of the baery may result in hazard of explosion.
Replace with the same or equivalent type only. Dispose of used baeries
according to the instrucons provided by the baery manufacturer.
•Input voltage should meet both the SELV and the Limited Power Source
according to 60950-1 standard.
•The power supply must conform to LPS. The recommended adaptor models and
manufacturers are shown as below. Use the aached adapter, and do not
change the adaptor randomly.
Model Manufacturer Standard
ADS-24S-12 1224GPCN SHENZHEN HONOR
ELECTRONIC CO.,LTD
CEE
G0549-240-050 SHENZHEN GOSPELL DIGITAL
TECHNOLOGY CO.,LTD
CEE
TS-A018-120015Ec SHENZHEN TRANSIN
TECHNOLOGIES CO., LTD
CEE
Door Staon Quick Start Guide
vii

Contents
1 Remote Operaon ...................................................................................... 1
1.1 Acvate Device .................................................................................................. 1
1.2 Edit Network Parameters .................................................................................. 2
1.3 Add Device ........................................................................................................ 3
1.4 Call Resident ...................................................................................................... 4
1.4.1 Dial via Main Unit ..................................................................................... 4
1.4.2 Dial via Nametag Module ......................................................................... 5
A. Extension Modules .................................................................................... 7
Door Staon Quick Start Guide
viii

1 Remote Operaon
The Video Intercom module provides remote control and conguraon on video
intercom products via the iVMS-4200 client soware.
1.1 Acvate Device
You can only congure and operate the door staon aer creang a password for
the device acvaon.
Default parameters of door staon are as follows:
•Default IP Address: 192.0.0.65.
•Default Port No.: 8000.
•Default User Name: admin.
Steps
1. Run the client soware, enter Device Management, check the Online Device
area.
2. Select an inacvated device and click the Acvate.
Figure 1-1 Online Device Area
3. Create a password, and conrm the password.
Figure 1-2 Acvate Device
Door Staon Quick Start Guide
1

Note
We highly recommend you to create a strong password of your own choosing
(using a minimum of 8 characters, including at least three kinds of following
categories: upper case leers, lower case leers, numbers, and special
characters) in order to increase the security of your product. And we
recommend you reset your password regularly, especially in the high security
system, reseng the password monthly or weekly can beer protect your
product.
4. Click OK to acvate the device.
Note
•When the device is not acvated, the basic operaon and remote operaon
of device cannot be performed.
•You can hold the Ctrl or Shi key to select mulple devices in the online
devices, and click the Acvate buon to acvate devices in batch.
1.2 Edit Network Parameters
To operate and congure the device via LAN (Local Area Network), you need connect
the device in the same subnet with your PC. You can edit network parameters via
iVMS-4200 client soware.
Steps
1. Select an online acvated device and click the Modify Nenfo.
Figure 1-3 Edit Network Parameters
2. Edit the device IP address and gateway address to the same subnet with your
computer.
3. Enter the password and click OK to save the network parameters modicaon.
Door Staon Quick Start Guide
2

Figure 1-4 Modify Parameters
Note
•The default port No. is 8000.
•The default IP address of the door staon is 192.0.0.65.
•Aer eding the network parameters of device, you should add the devices
to the device list again.
1.3 Add Device
To congure the device remotely, you need to add the device to iVMS-4200 client
soware.
Steps
1. Select the acvated device and click Add to Client.
Figure 1-5 Add Device
2. Enter corresponding informaon, and click Add.
Door Staon Quick Start Guide
3

Figure 1-6 Add to the Client
1.4 Call Resident
You can call residents via the door staon.
1.4.1 Dial via Main Unit
Steps
1. Select device, click Remote Conguraon.
Figure 1-7 Remote Conguraon
2. Click Intercom → Dial to enter the dial sengs page.
Door Staon Quick Start Guide
4

Figure 1-8 Dial Sengs Page (Private SIP)
Figure 1-9 Dial Sengs Page (Standard SIP)
3. Enter the Room No. of the indoor staon which the main unit connected to. You
can call corresponding resident by press the call buon on the main unit.
1.4.2 Dial via Nametag Module
Steps
1. Select device, click Remote Conguraon.
Figure 1-10 Remote Conguraon
2. Click Intercom → Sub Module to enter the sub module conguraon page.
Door Staon Quick Start Guide
5

Figure 1-11 Sub Module Conguraon Page
3. Select Nametag Module to pop up the conguraon window.
4. Enter Room No. for each call buon, and click Save.
Door Staon Quick Start Guide
6

A. Extension Modules
Module Door staon has the modules below:
Table A-1 Modules
Model Appearance Descripon
DS-KD-KK Nametag Module
DS-KD-IN Indicator Module
DS-KD-KP Keypad Module
DS-KD-M(E) Card Reader Module
DS-KD-BK Blank Module
Door Staon Quick Start Guide
7

UD13578B