HobbyZone Carbon Cub S+ 1.3M User manual

Carbon Cub S+1.3M Action Card
Flight Modes
Virtual Fence Selection (Mode 2 transmitter shown)
Compass Calibration
Deactivating GPS
Flight Mode TX Switch Position
Beginner FM 0
Intermediate FM 1
Advanced FM 2
Holding Pattern* Press and release HP/AL(Bind)
AutoLand* Press and hold (3seconds)
HP/AL (Bind)
* Changing the flight mode switch or pressing the HP/AL (bind)
button will interrupt Holding Pattern or AutoLand Modes.
Hold the transmitter sticks as shown while the aircraft GPS
system is initializing to change the active Virtual Fence Mode.
Virtual Fence OFF
•Low throttle
•Full right aileron
•Full up elevator
Circle Virtual Fence, Small (Default)
150m radius from home location
•Low throttle
•Full left aileron
•Full up elevator
Circle Virtual Fence, Large
250m radius from home location
•Low throttle
•Full left aileron
•Full down elevator
Airfield Virtual Fence*
400m long x 200m wide flight area with
no fly zone set 4m from the home location
•Low throttle
•Full right aileron
•Full down elevator
* Airfield Virtual Fence requires the additional selection of a flying
area direction based on the specified home location.
Compass calibration should be performed before the first flight
and whenever the aircraft is flown at a new location. Refer to the
product manual for complete compass calibration instructions.
Push and hold the HP/AL (bind) button and fully cycle the flight
mode switch 3 times. Power cycle the aircraft to re-activate.

©2017 Horizon Hobby, LLC. HobbyZone and the HobbyZone logo are registered trademarks of Horizon Hobby, LLC.
Cub Crafters, Carbon Cub, associated emblems and logos, and body designs of vehicles are either registered trademarks
or trademarks of Cub Crafters, Inc. and are used with permission. US 9,056,667. US 8,672,726. D774,933.
Created 08/17 56511 HBZ3200, HBZ3250
Aircraft Indicators and Meanings
Aircraft Indicator Indicator Meaning
Full up elevator, full left rudder
and aileron at power up Aircraft searching for RF link
Elevator moving up and down
slowly Aircraft searching for GPS lock
Elevator at full down and ESC
does not arm
AUX1 channel is reversed. See
the Transmitter Setup section of
the manual
Ailerons wag left and right after
inputing a Virtual Fence Mode
change command
Virtual Fence Mode change
accepted
Throttle pulses slowly after GPS lock Aircraft ready to set home location
Ailerons wag left and right after
setting home location and heading
Home location and heading
successfully set
No throttle after setting home
location and heading
Airfield Virtual Fence is active.
Flying area direction must be
set before throttle will function
All surfaces wag after setting
Airfield Virtual Fence area direction
Aircraft is ready to fly in Airfield
Virtual Fence mode.
Aircraft Indicator Indicator Meaning
In flight, the aircraft turns back
toward home location and
wings wag
Aircraft has hit virtual fence and
flown back to within the fence.
The wings wag to indicate control
is given back to the pilot
In flight, the aircraft turns back
toward and loiters over the home
location Hold Position Mode is active
In flight, the aircraft maneuvers
to 90m downwind of the home
location, 20m altitude and turns
to a final landing approach
AutoLand Mode is active
After AutoLand, the aircraft
does not respond to com-
mand inputs
Autoland Mode is still active.
Change the flight mode switch
or press and releas the HP/
AL (bind) button to deactivate
AutoLand Mode.
Rudder wags left and right
after deactivating GPS GPS deactivation confirmed