Hollywood Racks HR150 User manual

Caution:
Drive slowly when on rough or dirt roads
Always recheck tightness of knobs and straps
Maximum weight on rack is 35 Kg
For use on 50 mm tow balls ONLY
1.
Unfold rack
–
but
DO NOT clamp open
2. Rotate bike support arms forward (Fig. 1)
3. Mount bike carrier on tow ball so that the tow
ball is INSIDE of safety ring.(Fig. 2)
4. Push down on center handle until it snaps into
place. Insert pin through safety handle (Fig. 3)
5. Swing safety ring onto latch, hold in place while
tightening the knob (Fig. 4)
Model HR150 Tow Ball Rack –2Bike Capacity
Fig. 1Fig. 2
Fig. 3
Fig. 4

Limited One Year Warranty:
This rack is warranted for a period of one year against defects in materials and
workmanship, effective from the date of purchase to the original
purchaser. The manufacturer will repair or replace any
defective parts due to materials or workmanship. The manufacturer of this product shall not extend the warranty to 1) Any
failure or malfunction of the product due to any modification to the product; or 2.) Damages not attributable to a defect in
materials or workmanship; or 3.) Damages resulting from improper installation on the vehicle or attachment of bicycles on
rack. Consequential or Incidental Damages: The manufacturer shall not be liable for any consequential or incidental
damages in connection with the purchase, use or handling of this bike rack. Purchaser’s Rights: Some states do not
allow the exclusion or limitation of consequential or incidental damages and the above limitation may not apply
to you. This
warranty gives you specific legal rights and you have other rights, which vary from state to state.
Hollywood Racks 12812 S. Spring Street Los Angeles, CA 90061 Made in Taiwan
www.hollywoodracks
.com Tel.[phone] FAX [phone] Email: [e-mail]
5. Attach side straps to trunk/boot lid
Pull strap end through buckle to tighten.
(Fig. 5)
Installing the bicycles on the rack:
Place the heaviest bike onto the rack first
(closest to the vehicle), putting the bikes
top tube into the rubber bike cradles.
Pull the rubber strap across the bike’s
frame tube and attaché it to the cradle.
Repeat for the other cradle.
Repeat for second bike, but with the
handlebars on the opposite side
After both bikes are mounted to the rack,
use the nylon webbing tie down strap to
secure the bikes to the rear frame of the
rack itself.
Removing the rack from the vehicle:
Press on the spring buckles to loosen the
side straps.
Loosen the knob on the safety ring and let
the ring disengage from the latch
Remove pin from center handle, then
carefully squeeze and lift up on handle to
release rack from tow ball.
Fig. 5