HOMCOM 820-250V70 Installation guide

ASSEMBLY & INSTRUCTION MANUAL
IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY
INcjd080_UK
INcjd080_UK_820-250V70

1
This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved. Children shall not
play with the appliance. Cleaning and user maintenance shall not be made by
children without supervision.
- Children of less than 3 years should be kept away unless continuously
supervised.
Children aged from 3 years and less than 8 years shall only switch on/off the
appliance provided that it has been placed or installed in its intended normal
operating position and they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the hazards involved. Children
aged from 3 years and less than 8 years shall not plug in, regulate and clean the
appliance or perform user maintenance.
CAUTION - Some parts of this product can become very hot and cause burns.
Particular attention has to be given where children and vulnerable people are
present.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
- CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal
cutout, this appliance must not be supplied through an external switching device,
such as a timer, or connected to a circuit that is regularly switched on and off by the
utility.
- WARNING: In order to avoid overheating, do not cover the heater.
- The heater must not be located immediately below a socket-outlet.
- Do not use this heater in the immediate surroundings of a bath, a shower or a
swimming pool.
In order to prevent the risks of a fire, an electrical shock, burns and other injuries, it
is imperative to observe basic safety measures when using electrical appliances.
Please read the following information carefully before using the appliance for the
first time for your own safety and to ensure correct use.

2
SAFETY INSTRUCTIONS
When using any electrically powered product, basic safety precautions should
always be followed, including the following:
PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE USING THE PRODUCT.
WARNING - to reduce the risk of fire, electrical shock or injury to persons or property:
1. Always operate the product from a power source of the same voltage, frequency
and rating as indicated on the product identification plate.
2. Remove the unit from its packaging and check to make sure it is in good condition
before using.
3. Do not let children play with parts of the packing ( such as plastic bags)
4. Close supervision is necessary when the product is used by or near children or
infirm persons. Do not allow children to use it as a toy.
5. Do not operate any product with a damaged cord or plug, or after the product
malfunctions, or is dropped or appears damaged in any way. Return the complete
product to the place of purchase for inspection, repair or replacement.
6. Before unplugging the power cord, be sure to turn the power off. When touching
the unit, be sure your hands are dry to prevent electrical shock.
8. Ensure the cord is fully extended before use and arrange it so that it is not in
contact with any part of the heater.
9. In use, some parts of the heater are hot. When moving, hold the heater only by
the handle provided.
10. Do not use the heater in areas such as garages where petrol, paint or other
flammable substances are used or stored.
11. Do not use near or point the heater to furniture, animals, curtains or other
inflammable objects. Keep combustible materials such as furniture, bedding and
any other combustible materials at least 1 metre from the front and sides, and
from the rear of the heater.
12. Do not place the cord under carpet or cover with throw rugs or furniture. Arrange
the cord so that it cannot be tripped over.
13. Do not place the heater on bedding or on thick and long pile carpet where the
openings may be blocked.
14. To reduce the risk of electric shock, do not immerse or expose the product or
flexible cord to rain, moisture or any liquid other than those necessary for correct
operation of the product.
15. This product should not be used in the immediate vicinity of water, such as
bathtub, washbowls, bathroom swimming pool etc. where the likelihood of
immersion or splashing could occur.
16. Switch off and unplug from outlet when not in use, before assembling or
disassembling parts and before cleaning. Remove by grasping the plug - do not
pull on the cord.
17. A common cause of overheating is deposits of dust and fluff entering the heater.
Ensure these deposits are removed regularly by unplugging the heater, allowing
it to cool and cleaning as described in the Care, Cleaning and Storage section.
18. Be sure that no other high current appliances are plugged into the same circuit
with your heater as an overload can occur.
19. Avoid the use of an extension cord as the extension cord may overheat and cause
a risk of fire.
20. Do not use the appliance for other than its intended use.
21. Do not use outdoors. FOR INDOOR USE ONLY.
22. Do not leave the appliance unattended when switched on.
23. Do not place objects on the product or allow objects to obstruct the inlet or outlet
openings, or operate in close proximity to walls or curtains, etc. Do not cover the
unit when in operation.
24. Do not locate the heater immediately below a socket-outlet.

3
25. The use of attachments or accessories not recommended or sold by the product
distributor may cause personal or property hazards or injuries.
26. This product is intended for normal domestic/household use only.
Use this heater as described in this manual. Any other uses, not recommended by
the manufacturer, may cause fire, electric shock, or injury to persons and may
void the warranty.
CLEANING/ MAINTENANCE INSTRUCTIONS:
During Season Care:
● Before cleaning, be sure to turn off and unplug the heater.
● Carefully wipe the unit with a soft, damp cloth. Please be very cautious near the motor
and heating elements.
● Do not immerse the heater in water.
● Never use gasoline, benzene or thinner. This will damage the surface of the heater.
● After cleaning, be sure to completely dry the unit with a cloth or towel.
After Season Care:
● Store heater in a cool and dry location with power cord properly secured.
● Please store the unit in its original carton or suitable container.
PRE—OPERATING INSTRUCTIONS:
● Carefully remove your heater from the box (please save the carton for off-season
storage)
● Make sure the unit is in the OFF position before plugging the heater into the outlet.
● Place heater on a firm level surface.
OPERATING INSTRUCTIONS:

4
--Before inserting the plug into an electrical outlet, make sure that the electrical supply in
your area matches that on the rating label on the unit.
--When plugged in, turn on the Main power switch at the back of the unit.
a) When in Standby mode, only the switch ON/OFF on the control panel will respond
to your touch, and the LED display shows the room temperature. Press ON/OFF to
access the rest of the control panel or remote control.Press it to the lower power,
press it again to turn off the heater.the unit will keep working 30 seconds of cool air
after turn off it . this design can protect item use longer.
b) Low Power: (Press “POWER” to switch it)
c) High Power: (Press “ POWER“to switch it)
d) TIMER: Press ” TIMER ” button repeatedly to set a period after which the heater will
turn itself off (From 0 hour to 8 hours)
e) + , - : adjust room temperature .Temperature setting from 10-49 degree. “+” to
increase the desired temperature and “-“ to decrease the desired temperature. (On
Remote control only)
f) Osc : Press “ OSC “to activate oscillation. Press it again to cancel.
g) Press ON/OFF to turn off the heater, the unit will keep working 30 seconds of cool
air after turn off it . this design can protect item use longer.
Warning: The heater will remain hot for some time after it is turned off; handle with
care.
REMOTE CONTROL
The remote control uses on button cell battery, type CR2025(3V).To remove the battery
carriage use your thumb to squeeze the release tab to the right and then pull the carriage
out. Place the battery into the carriage and slide the carriage back into the remote. See
Fig.1. We recommend the use of a Lithium-ion battery for longer use. NOTE: Follow battery
disposal instruction on battery packaging, or contact your local safety council for safely
disposal of batteries.
Before using the remote control, you must remove the insulating film as shown in the figure
below.
1. All functions performed with remote control work identically to the heater control
panel.(Except the temperature settings)
2. Aim the remote control at the heater control panel to operate the heater.
OVERHEAT PROTECTION
This heater is protected with an overheat protection that switches off the appliance
automatically in case of overheat, e.g. due to the total or partial obstruction of the grids. In
this case, unplug the appliance, wait about 30 minutes for it to cool and remove the object
which is obstructing the grids. Then switch it back on as described above. The appliance
should operate normally. Should the problem persist, please contact the nearest customer
service.
TIP-OVER PROTECTION
This heater is protected with a safety switch that turns off the appliance automatically when
the heater falls over, or is at an excessive angle from the horizontal. This helps prevent
accidents, and the heater will back to the standby mode when it is put back upright, press
the buttons on control panel or remote control to reset the heater
SPECIFICATION
Model No 820-250V70
Voltage 220-240V AC
Frequency 50Hz
Output Power (W) 2000W