HOMCOM 820-313V00 User manual

INcji013V01_UK
UESR’S MANUAL
IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY
Rail Radiator
820-313V00

Blanking Plug
Air Vent
Washer
Long Screw
x1
x1
x8
x8
x8
x4
Masonry Wall Plug
HOOK
Dear customer,
Thank you for purchasing this product. For you to protect and install this
appliance properly, please read the manual thoroughly before using.
Keep this manual safe for future reference.
1. Product features
Pictures in this manual is for reference only – always refer to the actual
product. If you have any questions about the product and its features,
please contact customer service.
2. Accessory checklist
x4

3. Installation notes
1) Installation must be completed by a qualified person.
2) Dispose of all packaging in a responsible manner.
3) For installation, ensure the wall can hold the weight of this product. A
brick or cinderblock type wall is suitable.
4) This product is for indoors only.
5) Use a tape measure to insure there is enough space to fit this prod-
uct.
4. Towel rail installation:
- Read instructions carefully before installation.
- Installation must be completed by a qualified person.
- Dispose of all packaging in a responsible manner.
Tools required

Apply PTFE tape (not supplied) to the blanking plug – insert them into
the top left threaded holes. Apply PTFE tape (not supplied) to the air
vent plug – insert them into the top right threaded holes.
Use a wrench to secure the
blanking plug and air vent.

Mark the position of the wall bracket screws with a pencil, then drill
8mm holes into the marked position.
Tap the masonry wall plug into the hole.
Secure to the wall using a long screw, washer and spencer in that order
(hole facing out). See picture below.
Washer
Long Screw
x8
x8
x4
Masonry Wall Plug
HOOK
x8

Attention!
● Inspect the heater regularly. If you find any leaks, close the main valve
straight away.
● Be cautious of hot water to prevent scalding.
After installation:
● Use a screwdriver to open the air
vent, open the valve and let the water
flow into the product. Check all
connection points for possible leaks.
● Once the water flows from the air
vent, there will be no air in the tube.
● Use a screwdriver to close the vent,
then turn on the valve – the product is
ready to use.