4 2.991.999.120_en 07/2013
SP 5088
4 Commissioning 27
4.1 Baling press controls.........................................................................................27
4.1.1 Accessing the SERVICE menu.........................................................................................30
4.1.1.1Select setup mode (Bale finished / press channel / press ram)............................................31
4.1.1.2To display / clear the daily bale meter...................................................................................32
4.1.1.3Displaying / adjusting: Bale length or No. of strokes.............................................................32
4.1.1.4Displaying / adjusting the actual values................................................................................33
4.1.1.5Adjusting the user language..................................................................................................33
4.1.1.6To display the error memory..................................................................................................34
4.1.1.7System..................................................................................................................................34
4.2 Shredder control panel......................................................................................35
4.2.1 Display: Baling press not in automatic mode....................................................................35
4.2.2 Display: Status of the baling press....................................................................................35
4.3 Initial start-up.....................................................................................................36
4.4 Running in the baling press...............................................................................37
4.4.1 Setting the press channel adjustment cylinder.................................................................39
4.4.2 Relieve the press channel.................................................................................................40
4.5 Drawing in the strapping tape............................................................................41
4.6 Automatic compression with light barrier...........................................................42
4.7 Strapping procedure..........................................................................................42
4.8 "Sacking" procedure..........................................................................................44
4.9 Malfunctions of the baling press........................................................................45
4.9.1 Error numbers...................................................................................................................45
4.10 Malfunctions of the shredder.............................................................................46
4.10.1Overload due to paper jam ..............................................................................................46
4.10.2Electric motor overheats...................................................................................................46
4.10.3Emergency stop activated.................................................................................................46
4.10.4Oil reservoir empty............................................................................................................47
4.11 Stopping the machine........................................................................................47
4.12 Outdoor use.......................................................................................................47
5 Inspection and maintenance work 48
5.1 Notes on maintenance.......................................................................................48
5.2 Maintenance of the baling press........................................................................49
5.2.1 Changing the hydraulic fluid / venting filter.......................................................................49
5.2.2 Oiling and greasing moving parts .....................................................................................50
5.2.3 Empty the dust tray...........................................................................................................51
5.3 Maintenance of the FA500.3 shredder .............................................................52
5.3.1 Lubricating the drive chains and synchronized wheels (2 x per year)..............................52
5.3.2 Retighten the feed belt......................................................................................................53
5.3.3 Check the directional stability of the feed belt ..................................................................53
5.3.4 Check the feed belt for wear.............................................................................................53
5.3.5 Emptying the collecting tray..............................................................................................54
