HSS Hire Youngman Megastep Troubleshooting guide

944/02
944/02
Glass Fibre Step
Ladders
Glass Fibre Step
Ladders
Operating & Safety Guide 944
Operating & Safety Guide 944
A range of non–conductive
platform steps for use in
environments where electricity
is a hazard.
Code 84606/08/10
Never push the equipment beyond its design limits. If
it does not enable you to do what you want with
reasonable ease, assume you have the wrong type of
access equipment for the job. Contact your local HSS Hire
for advice.
When not in use, store the equipment somewhere
clean, dry and safe from thieves.
Tie steps in the closed position before transporting
them. If transporting on a roof rack, tie down
securely.
Fold the steps up and give them a final clean up ready
for return, to your local HSS Hire.
FINISHING OFF
EQUIPMENT CARE
©HSS Hire Service Group Ltd 2020 No. 944/02
76 Talbot Road, Old Trafford, Manchester, M16 0PQ
www.hss.com
…any comments?
If you have any suggestions to enable us to improve the
information within this guide please e-mail your comments or
write to the Safety Guide Manager at the address below
e-mail: [email protected]
... have you been trained
The law requires that personnel using this type of equipment in
the workplace must be competent and qualified to do so.
Training is available at HSS Training
0845 766 7799

For advice on the safety and suitability of this
equipment contact your local HSS Hire.
There is a serious risk of personal injury if you do not
follow all instructions laid down in this guide.
The hirer has a responsibility to ensure that all
necessary risk assessments have been completed prior
to the use of this equipment.
This equipment should only be used by an operator who
has been deemed competent to do so by his/her employer.
This equipment should be used by an able bodied,
competent adult who has read and understood these
instructions. Anyone with either a temporary or permanent
disability, should seek expert advice before using it.
Keep children, animals and bystanders away from the
work area. Cordon off a NO GO area using cones and
either barriers or tape, available for hire from your
local HSS Hire.
Never use this equipment if you are ill,
feeling tired, or under the influence of
alcohol or drugs.
Wear sensible, suitably protective clothing
and footwear plus any safety wear
appropriate to the work in progress.
Never let more than one person onto the steps any
one time.
Don’t attempt to use access equipment unless you feel
comfortable working at heights.
During use, make sure there is someone close by to
summon help in the event of accident.
Never carry tools or material while climbing unless you
can do so leaving your hands free, by carrying the
equipment in a shoulder bag.
Do not use this equipment near over-head or wall
mounted power cables and similar hazards.
Never use the steps in very windy or blustery
conditions.
The steps are designed to provide access for light
maintenance work. Never use them as a work platform.
GENERAL SAFETY
Check the equipment’s condition before use. If it
shows signs of damage or excessive wear – notably to
ladder feet, rungs or bracing bars, return it to your local HSS
Hire immediately.
Ensure the work area is well lit and ventilated, if in
doubt, ask about lighting and ventilation equipment at
your local HSS Hire.
Keep you feet in the middle of the rung/steps and climb
gripping the side firmly with both hands. Always climb
on the outer face never on the underside.
Never lean to one side to reach and never do
anything that involves applying a lot of force, the
steps could topple over.
Always set the steps up on a firm, level, non-slip
surface. On soft ground, stand the steps on boards to
stop it sinking in. Alternatively, hire a ladder safety foot from
local HSS Hire. Make sure the step ladders are fully
extended, never use them partly open. The steps have a
hinged brace fitted between the two sections, these
must be locked before using the steps. Before
entering the platform ensure the platform safety chain
is in place and it functions correctly.
GETTING STARTED
Hinged
Brace
Platform
Glass Fibre Step Ladders
Ladder Safety
The Max safe working load is 175 KG, the total
weight of the user and tools must not exceed this.
Never use the steps in the closed position acting as a
ladder or a ramp with boards.
Never use the steps for work that requires the use of
both hands.
Never stand on the top 3 rungs, either use a taller set
or use an access tower.
When moving to a new site, carry the steps with
care.

Pe
Petrol Di Diesel
Ro
Read OPS Guide Ou Outdoor Use only Hl Heavy Lifting Cd
Check Oil daily
Cc
Cleaning Charge Rc Repair Charge
Know Your Symbols
Correct PPE
must be worn
General use PPE / Warning
Fuel and Supply Types
Safe Procedures
Return Responsibility
Clearly marked minimum PPE
will be visible on all equipment,
All hirers must understand and
respect the safe procedures
of all equipment.
It is the responsibility of the hirer
to maintain and return the
equipment in a clean condition
and good working order.
Charges apply to equipment
returned dirty and damaged.
HSS have created clear Icons to inform the hirer of
their responsibilities towards the safe use of hire equipment.
These are designed to reduce the amount of different safety
information labels required for each product for hire.
Danger
Electric shock
2t
2 - Stroke Petrol
Cf
Check Fuel daily
Cw
Check Water daily
Ea
Must be Earthed
Class 1
Doi
Double Insulated
Class 2
21
Swl
Refer to Data Plate
SWL
V
Check Power
Voltage Data Plate
V
Danger
Rotating blade Danger Hot exhaust
HAV
Hand Arm Vibration
Caution
Abrasive Wheel Caution Finger trap
El
Electric
Electrical Safety
Safe wiring procedures. Enl
Earth Live Neutral
Wire Coding
E
N
L
!
PPE
Bc
Battery Care Sh
Safe Height
Working
Pe
Petrol Di Diesel
Ro
Read OPS Guide Ou Outdoor Use only Hl Heavy Lifting Cd
Check Oil daily
Cc
Cleaning Charge Rc Repair Charge
Know Your Symbols
Correct PPE
must be worn
General use PPE / Warning
Fuel and Supply Types
Safe Procedures
Return Responsibility
Clearly marked minimum PPE
will be visible on all equipment,
All hirers must understand and
respect the safe procedures
of all equipment.
It is the responsibility of the hirer
to maintain and return the
equipment in a clean condition
and good working order.
Charges apply to equipment
returned dirty and damaged.
HSS have created clear Icons to inform the hirer of
their responsibilities towards the safe use of hire equipment.
These are designed to reduce the amount of different safety
information labels required for each product for hire.
Danger
Electric shock
2t
2 - Stroke Petrol
Cf
Check Fuel daily
Cw
Check Water daily
Ea
Must be Earthed
Class 1
Doi
Double Insulated
Class 2
21
Swl
Refer to Data Plate
SWL
V
Check Power
Voltage Data Plate
V
Danger
Rotating blade Danger Hot exhaust
HAV
Hand Arm Vibration
Caution
Abrasive Wheel Caution Finger trap
El
Electric
Electrical Safety
Safe wiring procedures. Enl
Earth Live Neutral
Wire Coding
E
N
L
!
PPE
Bc
Battery Care Sh
Safe Height
Working