HTC HD2 Assembly instructions

HTC HD2
Screen Repair Guide
LCD & Touch Screen Repair

For more instructional repair guides for other makes or models, view our full catalog of Repair Guides!
This guide for the HTC HD2 has been put together by the RepairsUniverse team and will walk you through the
disassembly of the windows smartphone. Following this guide will allow you to replace and repair many parts such as the
glass touch screen digitizer, LCD display screen, camera, button replacements, and much more.
This guide will help you to install the following HTC HD2 part(s):
•HTC HD2 LCD Screen Replacement Display Replacement
•HTC HD2 Glass Touch Screen Digitizer Replacement
•HTC HD2 Loud Speaker Replacement
•HTC HD2 Ear Speaker Replacement
•Other HD2 Replacement Parts
Tools Required:
•Safe Open Pry Tool
•T5 Torx Screwdriver
•Hot Air Gun / Hair Dryer (optional)
HTC HD2 Written Repair Guide:
•First remove the battery cover and battery from the HD2.
•Now you will need to remove four T-5 Torx screws from housing surrounding the battery. Apply pressure to the
area of the battery and use a safe open pry tool to release the housing from the chassis.
•Using your pry tool, slide it along the outside edges until the housing is removed from the chassis, as shown in
Figure 1.
Figure 1
•Remove the 5 Torx Screws from the Chassis located in Figure 2. Remove the flash cable connector from the
motherboard to the flash frame camera. Use a safe open pry tool to pop the black antenna cable from the
motherboard and upper board.

Figure 2
•Then remove the keyboard flex cable connector from the motherboard. Do this by using a safe open pry tool to lift
up on the alligator clip, and remove the ribbon. Remove the label located below the battery.
•Pop the white cable from the GPS unit located in the left top corner and work your way to the motherboard.
Remove the GPS board
•Now, release the volume flex from the housing. Use a safe pry tool to remove the adhesive holding the
motherboard flex cable in place.
•You can now flip the motherboard and flex to the side, exposing the LCD flex cable connector. Use a pry tool to
move the clip forward and release the cable as shown in Figure 3.
Figure 3
•Use a hair dryer or heat gun to heat the front of the digitizer, working in quick movements for 1-2 minutes.
•Slide a safe open pry tool along the edges to remove the metal housing from the screen assembly as shown in
Figure 4.

Figure 4
•Remove the buttons from the lower portion of the digitizer. Slide a pry tool in between the LCD screen and
digitizer to separate the two.
•You can now replace either the touch screen digitizer or the LCD screen.
.
Your HTC HD2 is now disassembled and ready for replacement of part(s). Reverse the instructions
above to reassemble your HD2.
Notice:
Repairs Universe's guides are for informational purposes only. Please click here for details.
Learn about restrictions on reproduction and re-use of Repairs Universe's repair/take-apart/installation guides, and about
creating hyperlinks to our guides.