Huffy Green Machine User manual

HGM-16 EN 110513 m0023-bk
Copyright Huffy Corporation 2013
Owner’s Manual
16” Green Machine
Assembly Instructions
Date of Purchase: ___________________
Please write the date of purchase.
You should also retain the sales receipt.
THIS DOCUMENT CONTAINS IMPORTANT SAFETY INFORMATION.
READ AND KEEP FOR FUTURE REFERENCE.

2 2
PLEASE READ AND FULLY UNDERSTAND THIS OWNERS MANUAL BEFORE OPERATING THE PRODUCT
This symbol is important. It is the WARNING symbol. The warning symbol precedes safety instructions. Failure to fol-
low these instructions may result in injury to the rider or to others, or damage to the product.
All wheeled vehicles will provide safe, enjoyable transportation and recreation when used and maintained properly. Like
bicycling, skateboarding, and in-line skating, riding can be dangerous even under the best of circumstances. We do not want
you to get hurt. Please follow all safety rules and operating instructions.
This toy should be used with caution since skill is required to avoid falls or collisions causing injury to the user or third par-
ties.
WARNING:
• Adult assembly is required.
• Continuous adult supervision is required.
• Product does not have a brake - operator back pedals to slow or stop.
• Ensure rider can reach the pedals through full range of motion.
• Always wear a CPSC approved helmet while riding, with the chinstrap securely fastened.
• Always wear shoes when riding.
• Ride on smooth paved surfaces. Do not ride on streets or roadways.
• Always comply with local laws and regulations.
• Never use near motor vehicles.
• Do not ride on hills, steeply sloped areas, on or near steps, near swimming pools, or in alleys.
• Do not ride the product at dusk, at night or at times of limited visibility.
• Do not ride off road, on grass or wet surfaces.
• Do not ride the product over curbs or bumps that can damage the steering mechanism.
• Do not ride the product without the flag installed.
• Do not wear headphones or anything else that would impair your ability to hear or see.
• Do not jump or ramp product.
Safety and Warning Information

3 3
• Do not tow the product.
• Do not pull any objects with the product.
• Do not push the product.
• Never ride with more than one person. Maximum weight is 80 lbs (36Kg).
• This product should only be used by persons 5+ years of age.
• Excessive weight may cause a hazardous or unstable condition.
• Replace worn or broken parts immediately.
• If anything does not operate properly, discontinue use.
• Understand all operating procedures before riding.
• Do not add a motor to the product.
• Do not modify the product.
• Before each ride check all screws and fasteners; re-tighten any that are loose. Replace any fasteners that are damaged.
• Know your limits. Be familiar with your abilities. Use common sense.
Safety and Warning Information - continued

4 4
Tools necessary for assembly:
Phillips screwdriver
The instructions in this manual refer to the right and left side of the product, these are defined from the rider position.
Do not discard any parts until the unit is completely assembled.
WARNING:
Wheels & Axle:
• The wingnuts must be securely tightened to ensure rear wheels do not come loose from the axle.
• All hardware must be sufficiently tightened to ensure it does not come loose.
Pivot Bolt:
Pivot hardware must be correctly installed to ensure they do not come loose.
Steering Function:
• Over tightening the steering linkage may prevent the steering from operating properly.
• Pulling back on the right lever, and pushing forward on the left lever will turn the product towards the right.
• Pulling back on the left lever, and pushing forward on the right lever will turn the product towards the left.
• Steering this product takes some practice. Ensure the rider can properly steer the product. Practice in an open area.
Seat:
Secure the seat bolt each time the seat is moved.
Flag:
The flag is provided to make the rider and the product more visible. Do not use the product without the flag installed.
Assembly Notes

5 5
(both sides)
(both sides)
LABEL SHEET
NOTE: APPLY LABELS PRIOR TO ASSEMBLY
001
“Huy” and “Green Machine” are registered trademarks of Huy Corporation

6 6
315
316
x 1
x 1
336
338
315
316
341
315
316
341
341
301
305
300
337
WING BOLT MUST BE FULLY TIGHTENED BY HOLDING WING BOLTS
AT BOTH ENDS OF AXLE.
note
note
note
346
(x2)
1

7 7
303
x 2
345
x 2
304
x 2
303
303
304
304
302
301
345 305
300
345
306
2

8 8
310 309
310
307
306
306
342
308
x 1 Limiter Pin 307 x 1
B
C
A
3

9 9
335
x 2
334
x 2
311
312
314
315
316
313
335
335
335
335
334
334
ENSURE BUSHING
IS IN PLACE BEFORE
ASSEMBLY
note
B
C
A
4

10 10
311
314 315
315
316
316
317
x 1
x 1
(both wheels)
WING BOLT MUST
BE FULLY TIGHTENED
BY HOLDING WING BOLTS
AT BOTH ENDS OF AXLE.
B
C
A312
335
335
313
note
x 2 335
314
x 1
5

11 11
320
319
319
319
319
318 BA
DC
note OPPOSITE SIDE
6

12 12
322
321
321
324
323
323
322
324
x 4
x 4
320
note ROUND HOLES note
HEX HOLES
ORIENTATION
OF NUT
note
7

13 13
325
310
310
RH
x 4
326
321323
LH
note INSERT SCREWS FIRST
note
TURN UNIT UPSIDE DOWN
8

14 14
329
329
328
TOP
TOP
BOTTOM
BOTTOM
328
310
310
320
310
x 8
9

15 15
333
331
344
332 310
343
310
x 6
344
x 2
10

16 16
313
333
331
318
300
343
302
334
307
308
309
310
321
323
322
324 320
319
325
326
310 328
329
310
301
346
304
303
311
305
332
312
314
315
316
317
335
345
344
342
310
336
337
341
316
315
338

17 17
ASSEMBLY PARTS LIST
PAGE-ID No. DESCRIPTION PAGE-ID No. DESCRIPTION
Label Sheet 001 Label Sheet 4315 Washer (x1)
1300 Main Frame 316 Wing bolt (x1)
336 Left Arm 5317 End Cap (x2)
337 Right Arm 314 Bushing (x1)
338 Steering Shaft 315 Washer (x1)
315 Washer (x1) 316 Wing bolt (x1)
316 Wing Bolt (x1) 312 Hub Cap (x1)
341 Cap (x2) 313 Tire (x1)
305 Steering Linkage Left 335 Bushing (x2)
301 Steering Linkage Right 6318 Front Wheel
346 Bushing (x2) 320 Crank
2302 Rear Frame 319 Crank Keeper (x4)
303 Washer (x2) 7321 Keeper Plate (screw side)
304 Cap Nut (x2) 323 Keeper Plate (nut side)
345 Bushing (x2) 322 Screw (x4)
3308 Steering Keeper 324 Nut (x4)
306 Steering Tube 8325 Axle Bracket Right
342 Steering Limiter 326 Axle Bracket Left
307 Limiter Pin 310 Screw (x4)
309 Cap 9328 Top Pedal (x2)
310 Screw (x1) 329 Bottom Pedal (x2)
4311 Axle Shaft 310 Screw (x 8)
312 Hub Cap (x1) 10 331 Seat
313 Tire (x1) 332 U-Bolt
335 Bushing (x2) 333 Flag
334 Bushing Insert (x2) 343 Fender
314 Bushing (x1) 310 Screws (x6)
344 Wingnut (x2)

18 18
Part or model specifications are subject to change without notice.
This Limited Warranty is the only warranty for this product. There are no other expressed or implied warranties. The only
uses for this product are described in this manual. Warranty registration is not required. This limited warranty extends only to
the original consumer and is not transferable.
What does this Limited Warranty cover?
This Limited Warranty covers all parts of the product except the wheels, which have no warranty.
What must you do to keep the Limited Warranty in effect?
This Limited Warranty is effective only if:
• the product is completely and correctly assembled;
• the product is used under normal conditions for its intended purpose (see “Safety Information” for excluded activities);
• the product receives all necessary maintenance and adjustments.
What is not covered by this Limited Warranty?
This product is designed for recreational use only. This Limited Warranty does not cover normal wear and tear, normal main-
tenance items, or any damage, failure, or loss that is caused by improper assembly, maintenance, adjustment, storage, or
use.
This Limited Warranty is void if the product is ever:
• used for stunt riding, jumping, acrobatics, or similar activity;
• used in any competitive sport;
• installed with a motor;
• modified in any way;
• ridden by more than one person at a time, or the weight limit is exceeded;
• rented;
• used in a manner contrary to the instructions in this manual.
How long does this Limited Warranty Last?
Excluding the wheels, all components are warranted for six (6) months from the date of purchase.
Warranty Information

19 19
Warranty Information - continued
What will the manufacturer do?
The manufacturer will replace, without charge to you, any component that does not meet this warranty. The original owner
must pay all labor and transportation charges associated with the repair or warranty work.
How do you get service?
Phone Customer Service
What rights do you have?
This Limited Warranty gives you specific legal rights. You may also have other rights which vary from state to state.

H Helmet EN 100212 LB i0027
• Helmet should sit level on your head and low on your
forehead
• Adjust the strap sliders below the ear on both sides.
• Buckle the chin strap. Adjust strap until it is snug.
• No more than two fingers should fit between the strap and
your chin.
• A proper fitting helmet should be comfortable and not rock
forward/backward or side to side.
• Always read the user manual that comes with your helmet
to make sure it is fitted and attached properly to the wear-
er’s head according to the fitting instructions described in
the user manual.
CORRECT INCORRECT
Check www.Huffy.com for the current contact information
WARNING:
ALWAYS WEAR YOUR
HELMET WHEN RIDING
THIS PRODUCT!