Human Touch CITYclub ht3010 User manual

REMOVING THE CONTROLLER
1. Facing the back of the chair, pull up on the lower edge of the backrest cover then flip it over the top of
the backrest. (Fig.1)
2. Insert the end of a paper clip into the zipper, then open the zipper to expose the connector junction box. (Fig.2)
3. Follow the controller cord to the backrest until you locate the zip tie that secures the cord to the backrest. (Fig.3)
4. Using a nail clipper or other instrument suitable for cutting zip ties, cut and remove the zip tie. (Fig.3)
(Fig.1)
1
X1103
October 08, 2010
Tools Required: Phillips-head screwdriver, nail clipper or other instrument suitable for cutting zip ties, new zip tie, paper clip.
NOTE: SAVE ALL SCREWS FOR USE DURING REASSEMBLY.
REPLACING THE CONTROLLER
HT-3010
It is imperative that Human Touch®products are repaired in a manner that ensures product safety and regulatory compliance and that is fully consistent with the practices used
during the manufacturing process. Therefore, Human Touch requires that all product repairs are performed using only factory-new parts and in accordance with these repair
instructions. Failure to adhere to these instructions voids the product warranty and releases Human Touch from all liability for injury or product damage resulting from the repair.
SERVICE LEVEL: 2
Backrest cover
(Fig.2)
Connector
junction box
Controller cord
(Fig.3)
Zip ties
Nail clipper

2
5. Using a Phillips-head screwdriver, remove the four screws from the connector junction box cover, then remove the cover. (Fig.4)
6. Follow the controller cord to the connector junction box, then disconnect the controller connectors. (Fig.5)
7. Remove the controller from the chair. (Fig.5)
(Fig.4)
Controller connectors
(Fig.5) (Fig.6)
INSTALLING THE NEW CONTROLLER
1. Thread the controller cord through the opening in the backrest upholstery, then connect the new controller to the corresponding backrest connector.
2. Position the connectors inside the connector junction box, replace the junction box cover, then secure it using the four screws.
3. Use a paper clip to close the zipper.
4. Secure the cables together just outside the opening in the backrest upholstery using a new zip tie.
5. Flip the backrest cover back into position and secure it using the hook-and-loop fasteners.
Please send any questions or comments regarding these instructions to: [email protected]
© 2010 Human Touch®, LLC.