Human Touch CITYclub ht3010 Operating instructions

REMOVING THE POWER CORD
1. Power off the chair and unplug it.
2. Facing the back of the chair, pull up on the lower edge of the backrest cover then flip it over the top of
the backrest. (Fig.1)
3. Insert the end of a paper clip into the zipper, then open the zipper to expose the connector junction box. (Fig.2)
4. Follow the power cord to the backrest until you locate the zip tie that secures the cord to the backrest. (Fig.3)
5. Using a nail clipper or other instrument suitable for cutting zip ties, cut and remove the zip tie. (Fig.3)
(Fig.1)
1
X1103
October 29, 2010
Tools Required: Phillips-head screwdriver, nail clipper or other instrument suitable for cutting zip ties, new zip tie, paper clip.
NOTE: SAVE ALL SCREWS FOR USE DURING REASSEMBLY.
REPLACING THE POWER CORD
HT-3010
It is imperative that Human Touch®products are repaired in a manner that ensures product safety and regulatory compliance and that is fully consistent with the practices used
during the manufacturing process. Therefore, Human Touch requires that all product repairs are performed using only factory-new parts and in accordance with these repair
instructions. Failure to adhere to these instructions voids the product warranty and releases Human Touch from all liability for injury or product damage resulting from the repair.
SERVICE LEVEL: 2
Backrest cover
(Fig.2)
Connector
junction box
Controller cord
(Fig.3)
Zip ties
Nail clipper

2
6. Using a Phillips-head screwdriver, remove the four screws from the connector junction box cover, then remove the cover. (Fig.4)
7. Follow the power cord to the connector junction box, then disconnect the power cord connectors. (Fig.5)
8. Using a flat-head screwdriver, remove the screw that secure the green ground wire to the chair frame.
9. Remove the power cord from the chair. (Fig.6)
(Fig.4)
Power cord
(Fig.5) (Fig.6)
INSTALLING THE NEW CONTROLLER
1. Thread the power cord through the opening in the backrest upholstery, then connect the new power cord to the corresponding backrest connector.
2. Secure the ground wire to the chair frame using the screw you removed earlier.
3. Position the connectors inside the connector junction box, replace the junction box cover, then secure it using the four screws.
4. Use a paper clip to close the zipper.
5. Secure the cables together just outside the opening in the backrest upholstery using a new zip tie.
6. Flip the backrest cover back into position and secure it using the hook-and-loop fasteners.
7. Plug in the chair, power it on, then verify that the chair is receiving power.
Please send any questions or comments regarding these instructions to: [email protected]
© 2010 Human Touch®, LLC.