i3 International SBB41 User manual

Rev. 161110
Quick Start Guide
SBB41 Installation Guide SBB41
In the event that you must install a new SBB41 please follow these instructions.
Before beginning please ensure that:
• The packing foam used during shipping of the NVR system has been
removed from between the outer door and the front of the SBB41 units.
• That the NVR is powered down and disconnected from the power source
and other connections to the NVR.
i3 INTERNATIONAL INC.
1.866.840.0004
www.i3international.com Canada 780 Birchmount Road, Unit 16,
Scarborough, ON, M1K 5H4
U.S.A 4450 Witmer Industrial Estates Unit 4
Niagara Falls, NY 14305
INSTALLATION INSTRUCTIONS
1. Remove the Hard Drives from the SBB41 unit and carefully set them aside. If
the drive is not numbered make careful note of which drive came from which
bay. They will need to be in the same bay in the new SBB41
2. Remove the screws securing the lid of the NVR.
3. Once all the screws are removed lift the back of the lid and remove it from
the chassis.
4. Below is a view of the back of the SBB41 from inside the NVR chassis. Here
you can remove the Sata cables and the power cables from the SBB41. Be
sure to take particular note which Sata cable came from which drive bay.
They will need to be connected back to the same drive in the new SBB41.
5. Remove the 18 screws that secure the top bracket. 6 screws along the sides
and 12 on the top surface. These screws on the top simultaneously secure
the top bracket and the SBB41 to the chassis.
• It is paramount you properly ground yourself. Use an anti static strap to
ensure you stay grounded throughout the procedure.

Rev. 161110
6. Remove the top bracket. This will leave the SBB41 unsecured to the chassis
and allow it to be carefully lifted out afterward.
7. As long as the Sata and Power cables were removed as described in step 3
the SBB41 case can be carefully lifted out of the chassis.
8. Once the case containing the SBB41 is out of the chassis turn it on its side
and remove the screws securing it to the case. There are 6 screws on each
side of the case. Slide the SBB41 out of the case.
9. Place the new unit into the frame. Be sure to set in as shown with the Sata
and Power connectors on the right side of the fan and the frame.
10. Secure the SBB41 into the frame with the 12 screws taken from the
previous unit. Note that with the face of the SBB41 on your right the screws
are placed into the left most column of both pairs of screw holes on the
frame (see step 8 for screw placement details).
11. Place the SBB41 back into the case.
SBB41
INSTALLATION GUIDE

Rev. 161110
SBB41
INSTALLATION GUIDE
12. Make note that the round black feet on the frame set firmly with the tabs on
the bottom of the NVR case.
13. Replace the top bracket and secure it as shown.
14. Replace the hard drives. Note that both the Hard drives and the bays should
be numberedare numbered. Those numbers need to match. Drive 1 with
Bay 1 etc.
15. Reconnect the 2 power cables and the Sata cables to the SBB41 unit. Take
careful note that the cable for Drive 1 is connected to Drive one and so on.
16. Replace the lid to the NVR securing it with the screws removed earlier.
Reconnect the NVR to the system and power. Turn on the DVR.