IB Connect Box User manual

installation Guide
User manual

1 - 2
User manual
05
06
07
BOX PLUS COVER LAYER: To cover the Box
Plus cover with a finish that matches the desk
(wood or another material), cut a layer with the
same dimensions shown in figure 5.
Insert a flat-head screwdriver into the holes in
the rail tabs, levering, always towards the outside
of the box.
IMPORTANT:Both tabs must be unlatched
before the rail is pulled out.
IMPORTANT: If necessary, respect the position
and direction of the wood grain.
Contact adhesive is recommended for securing
the material to the cover (in the case of wood or
another porous material). For materials such
as leather or synthetic leather, do not use
adhesives containing cyanoacrylate.
Adhesive not supplied with the product.
User Manual
01
02
04
03
IMPORTANT: Do not exceed the tolerance
dimensions or the product will not be installed
properly.
Cut an opening in the desk to recess the box
with the measurements specified in figure 1.
Use a Phillips head screwdriver to screw the
tabs that you bent using the screws provided.
The box is completely installed.
Bend the four tabs that are best suited for holding
the box to the desk.
After you have cut the opening, insert the box
through the top of the desk.
For any questions on the profile frame, contact
us at:
[email protected]
1+0,2
-0
282 +0
-0,2
101+0
-0,2