IBM UPS1000THV User manual

IBM UPS750TLV/ UPS750THV
IBM UPS1000TLV/ UPS1000THV
IBM UPS1500TLV/ UPS1500THV
Tower Uninterruptible Power Supply
Operation and Maintenance Manual
02R2772

TABLE OF CONTENTS
Safety.............................................................................................................................................................................................1
Introduction...............................................................................................................................................................................4
1: INSTALLATION........................................................................................................................................................................4
Unpacking..................................................................................................................................................................................4
Positioning the Uninterruptible Power Supply.........................................................................................................................4
Battery Connection....................................................................................................................................................................5
Connecting Equipment and Power to the Uninterruptible Power Supply................................................................................5
Startup .......................................................................................................................................................................................6
2: OPERATION...............................................................................................................................................................................7
Front Display Panel .................................................................................................................................................................. 7
On Battery Operation................................................................................................................................................................8
Determining On Battery Runtime..............................................................................................................................................8
Battery Runtime Table...............................................................................................................................................................8
3: USER CONFIGURABLE ITEMS ............................................................................................................................................9
4: STORAGE, MAINTENANCE, AND TRANSPORTING ....................................................................................................11
Storage.....................................................................................................................................................................................11
Replacing the Battery Module................................................................................................................................................. 11
5: HARDWARE MAINTENANCE INFORMATION..............................................................................................................13
Field Replaceable Unit Part Numbers....................................................................................................................................13
6: TROUBLESHOOTING...........................................................................................................................................................14
7: GETTING HELP AND TECHNICAL ASSISTANCE.........................................................................................................16
Before you call......................................................................................................................................................................... 16
Using the Documentation........................................................................................................................................................ 16
Getting help and information from the World Wide Web ....................................................................................................... 16
Software service and support .................................................................................................................................................. 16
Hardware service and support................................................................................................................................................ 16
Replacement part handling...................................................................................................................................................... 17
8: SAFETY INFORMATION......................................................................................................................................................18
9: WARRANTY INFORMATION..............................................................................................................................................45
Part 1 - General Terms............................................................................................................................................................ 45
Part 2 - Country-unique Terms ...............................................................................................................................................47
Part 3 - Warranty Information................................................................................................................................................55
10: NOTICES, TRADEMARKS, AND RADIO FREQUENCY WARNINGS.......................................................................57
Notices ..................................................................................................................................................................................... 57
Attention! Life Support ............................................................................................................................................................57
Edition notice...........................................................................................................................................................................58
Trademarks..............................................................................................................................................................................58
Important notes........................................................................................................................................................................58
Product recycling and disposal............................................................................................................................................... 58
Battery return program ........................................................................................................................................................... 59
Electronic emission notices..................................................................................................................................................... 59
Power Cords............................................................................................................................................................................ 60

1
SAFETY Before installing this product, read the Safety Information.
Antes de instalar este produto, leia as Informações de Segurança.
Pred instalací tohoto produktu si prectete prírucku bezpecnostních instrukcí.
Læs sikkerhedsforskrifterne, før du installerer dette produkt.
Lees voordat u dit product installeert eerst de veiligheidsvoorschriften.
Ennen kuin asennat tämän tuotteen, lue turvaohjeet kohdasta Safety Information.
Avant d'installer ce produit, lisez les consignes de sécurité.
Vor der Installation dieses Produkts die Sicherheitshinweise lesen.
Prima di installare questo prodotto, leggere le Informazioni sulla Sicurezza.
Les sikkerhetsinformasjonen (Safety Information) før du installerer dette produktet.

2
Antes de instalar este produto, leia as Informações sobre Segurança.
Antes de instalar este producto, lea la información de seguridad.
Läs säkerhetsinformationen innan du installerar den här produkten.
WARNING: Handling the cord on this product or cords associated with accessories sold with this product, will
expose you to lead, a chemical known to the State of California to cause cancer, and birth defects or other
reproductive harm. Wash hands after handling.
ADVERTENCIA: El contacto con el cable de este producto o con cables de accesorios que se venden junto con
este producto, pueden exponerle al plomo, un elemento químico que en el estado de California de los Estados
Unidos está considerado como un causante de cancer y de defectos congénitos, además de otros riesgos
reproductivos. Lávese las manos después de usar el producto.

3
CAUTION! Handling Safety - Use safe practices when lifting.
<18 kg (<40 lb) 32–55 kg (70–120 lb)
18–32 kg (40–70 lb) >55 kg (>120 lb) >10º
CAUTION! Electrical Safety
Electrical Current from power, telephone, and communication cables is hazardous. Please read the following safety statements.
•Do not connect or disconnect any cables or perform installation, maintenance, or reconfiguration of this product during an electrical storm.
•Connect all power cords to a properly wired and grounded electrical outlet.
•Connect to properly wired outlets any equipment that will be attached to this product.
•When possible, use one hand only to connect or disconnect signal cables.
•Never turn on any equipment when there is evidence of fire, water, or structural damage.
•Disconnect the attached power cords, telecommunications systems, networks, and modems before you open the device covers, unless instructed otherwise
in the installation and configuration procedures.
•Connect and disconnect cables as described in the following table when installing, moving, or opening covers on this product or attached devices.
To Connect: To Disconnect:
1. Turn everything OFF.
2. First attach all cables to devices.
3. Attach signal cables to connectors.
4. Attach power cords to outlet.
5. Turn device ON.
1. Turn everything OFF.
2. First remove power cords from outlet.
3. Remove signal cables from connectors.
4. Remove all cables from devices.
•Do not work alone under hazardous conditions.
•High current through conductive materials could cause severe burns.
•Check that the power cord(s), plug(s), and sockets are in good condition.
•Use qualified service personnel to change the plug on the uninterruptible power supply.
•When grounding cannot be verified, disconnect the equipment from the utility power outlet before installing or connecting to other equipment. Reconnect
the power cord only after all connections are made.
•Do not handle any metallic connector before the power has been disconnected.
•Connect the equipment to a three wire utility outlet (two poles plus ground). The receptacle must be connected to appropriate branch circuit/mains protec-
tion (fuse or circuit breaker). Connection to any other type of receptacle may result in risk of electrical shock.
•HV models only:
•In order to maintain compliance with the EMC directive for products sold in Europe, output cords attached to the uninterruptible power supply
should not exceed 10 meters in length.
•Total leakage current from connected equipment and the uninterruptible power supply must not exceed 3.5 mA for a pluggable A Type uninterrup-
tible power supply.
CAUTION! De-energizing Safety
•The uninterruptible power supply has an internal energy source, the battery. The output may be energized when the unit is not connected to a utility power
outlet.
•To de-energize the uninterruptible power supply, press the OFF button to shut the equipment off. Unplug the uninterruptible power supply from the utility
power outlet. Disconnect the external batteries where applicable and disconnect the internal battery (see Operation and Setup Guide). Push the ON button
to de-energize the capacitors.
CAUTION! Battery Safety
•This equipment contains potentially hazardous voltages. Refer to your product documentation to determine which pats are user-replaceable.
•Do not dispose of batteries in a fire; they may explode.
•Do not open or mutilate batteries. They contain an electrolyte that is toxic and harmful to the skin and eyes.
•To avoid personal injury due to energy hazard, remove wristwatches and jewelry such as rings when replacing the batteries. Use tools with insulated han-
dles.
•Replace the battery module with the same number and type as originally installed in the equipment.
Be sure to deliver the spent battery to a recycling facility.

4
Introduction
The IBM®UPS750TLV, UPS750THV, UPS1000TLV, UPS1000THV, UPS1500TLV and UPS1500THV models are designed to
prevent blackouts, brownouts, sags, and surges from reaching your computer and other valuable electronic equipment. The
uninterruptible power supply filters small utility line fluctuations and isolates your equipment from large disturbances by inter-
nally disconnecting from the utility line. The uninterruptible power supply provides continuous power from the internal battery
until the utility line returns to safe levels or the battery is fully discharged.
1: INSTALLATION
Unpacking
Attention:
 Read the Safety Information in this documentation before you install the uninterruptible power supply.
 The uninterruptible power supply comes with its battery disconnected (see Battery Connection).
Note: Illustrations in this documentation might differ slightly from your hardware.
Inspect the uninterruptible power supply upon receipt. Accidents and damage can occur during shipment. Notify the carrier and
your IBM marketing representative or authorized reseller if there is damage.
The packaging is recyclable; save it for reuse or dispose of it properly.
Check the package contents:
 Uninterruptible power supply
 Uninterruptible power supply accessory kit containing:
 Product documentation
 PowerChute® CD
 Serial and USB communication cables- 2 m (6.5 ft)
 750TLV, 1000TLV and 1500TLV models only: One C-13 to NEMA 5-15 power cable -
2 m (6.5 ft)
 750THV model only: Three IEC jumper cables - 2 m (6.5 ft)
 1000THV and 1500THV models only: Four IEC jumper cables - 2 m (6.5 ft)
 1000TLV, 1000THV, 1500TLV and 1500THV models only: One RJ-45, CAT5 network
communication cable and one RJ-11 phone communication cable- 1.8 m (6 ft)
Positioning the Uninterruptible Power Supply
18–32 kg
(40–70 lb)
Attention: The uninterruptible power supply is heavy.
Select a location sturdy enough to handle the weight.
Do not operate the uninterruptible power supply in excessive dust or in temperature and humidity outside the specified limits.
PLACEMENT
2.5 cm
(
1 in.
)

5
Battery Connection
The battery connector is located on the rear panel (See Con-
necting Equipment and Power to the Uninterruptible Power
Supply).
For battery connection, push the connector into the corre-
sponding port.
Connecting Equipment and Power to the Uninterruptible Power Supply
REAR PANEL
750TLV
MODEL 750THV MODEL 1000TLV AND 1500TLV
MODELS
1000THV AND
1500THV
MODELS
INDEX ITEM DESCRIPTION
1 & 2 USB Port & Serial Port Power management software and either USB or serial port commu-
nication with the uninterruptible power supply can be used. Use only
cables supplied or approved by IBM.
Use the supplied serial cable to connect to the serial port. DO
NOT use a standard serial interface cable since it is incompatible
with the uninterruptible power supply connector.
Important: Serial and USB ports cannot be used simultaneously.
3 Site Wiring Fault LED 750TLV, 1000TLV and 1500TLV models only: See Troubleshooting.
4 TVSS Screw The uninterruptible power supply features a transient voltage surge-
suppression (TVSS) screw for connecting the ground lead on surge
suppression devices such as telephone and network line protectors.
When connecting a grounding cable, disconnect the unit from the
utility power outlet.
5 Smart Slot See Startup.
6 Battery Connector See Battery Connection.
7 Outlet Banks Connect equipment.
8 Input Cord 750TLV, 1000TLV and 1500TLV models only: See Startup.
9 Circuit Breaker See Troubleshooting.
10 Input Connector 750THV, 1000THV and 1500THV models only: See Startup.
11 Voltage Sensitivity Button and
LED 1000TLV, 1000THV, 1500TLV and 1500THV models only: See User Configurables.
12 Telephone/Network Surge Sup-
pression Ports 1000TLV, 1000THV, 1500TLV and 1500THV models only: For tele- phone/network surge suppression, connect a single line telephone or
a 10Base-T/ 100Base-Tx network cable into the RJ-45/RJ-11 tele-
phone/network surge protection port, , on the back of the unin-
terruptible power supply. Connect from the port with sup-
plied telephone or network cabling to a fax modem or network port.
2
1 3
6
4 5
9
8
7
2
1
10
6
4 5
9
7
5
236
4
1
89
7
11
12
2
10
6
4
1
5
9
7
11
12

6
Startup
1. Plug in the battery connector.
2. Connect equipment to the uninterruptible power supply.
Note: A laser printer draws significantly more power than other types of equipment and might overload the unin-
terruptible power supply.
3. Add any optional accessories to the Smart-Slot. This IBM uninterruptible power supply is compatible with APC Smart-Slot
options.
4. Plug the uninterruptible power supply into a two-pole, three-wire, grounded receptacle only. Do not use extension cords.
750TLV, 1000TLV and 1500TLV models only: The power cord is permanently attached to the rear panel of the uninterrup-
tible power supply.
750THV, 1000THV and 1500THV models only: A country or region specific power cord for the uninterruptible power sup-
ply is available as a separate option. Alternatively, you can use a power cord that comes with an IBM server that you intend
to connect to the uninterruptible power supply. Use only an IBM supplied or approved power cord to connect your uninter-
ruptible power supply to a power source.
5. Use the power cord or jumper cables that come with the uninterruptible power supply to connect servers or devices to the
uninterruptible power supply. Alternatively, you can use a jumper cable or power cord that comes with an IBM server that
you intend to connect to the uninterruptible power supply. Use only an IBM supplied or approved power cord or jumper
cable to connect servers or devices.
6. 750TLV, 1000TLV and 1500TLV models only: Check the site wiring fault LED located on the rear panel. It will be illu-
minated if the uninterruptible power supply is plugged into an improperly wired utility power outlet (See Troubleshooting).
7. Turn on all connected equipment. To use the uninterruptible power supply as a master on/off switch, be sure all connected
equipment is turned on.
8. To turn on the uninterruptible power supply, press the button on the front panel.
9. For optimal computer system security, install PowerChute monitoring software on all computers powered by the uninter-
ruptible power supply.