ICON Health & Fitness Weslo pursuit g 3.1 User manual

Serial Number Decal
CAUTION
Read all precautions and
instructions in this manual before
using this equipment. Keep this
manual for future reference.
Model No. WLEX61115C.0
Serial No.
Write the serial number in the space
above for reference.
USER’S MANUAL
weslo.com
To register your product and
activate your warranty today,
go to iconservice.ca.
Call toll-free 1-888-936-4266
Mon.–Fri. 7:30 a.m.–4:30 p.m. ET
(excluding holidays)
or email us at
[email protected]
Please do not contact the store.
ACTIVATE YOUR
WARRANTY
CUSTOMER SERVICE

2
TABLE OF CONTENTS
WARNING DECAL PLACEMENT
WARNING DECAL PLACEMENT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
IMPORTANT PRECAUTIONS..................................................................3
BEFORE YOU BEGIN. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
PART IDENTIFICATION CHART. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
ASSEMBLY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7
HOW TO USE THE EXERCISE BIKE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12
MAINTENANCE AND TROUBLESHOOTING.....................................................15
EXERCISE GUIDELINES ....................................................................17
PART LIST. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .18
EXPLODED DRAWING. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .19
ORDERING REPLACEMENT PARTS .................................................. Back Cover
LIMITED WARRANTY. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Back Cover
WESLO is a registered trademark of ICON Health & Fitness, Inc.
This drawing shows the location(s) of the
warning decal(s). If a decal is missing
or illegible, see the front cover of this
manual and request a free replacement
decal. Apply the decal in the location
shown. Note: The decal(s) may not be
shown at actual size.

3
WARNING: To reduce the risk of serious injury, read all important precautions and
instructions in this manual and all warnings on your exercise bike before using your exercise bike.
ICON assumes no responsibility for personal injury or property damage sustained by or through the
use of this product.
1. It is the responsibility of the owner to ensure
that all users of the exercise bike are ade-
quately informed of all precautions.
2. Before beginning any exercise program,
consult your physician. This is especially
important for persons over age 35 or per-
sons with pre-existing health problems.
3. The exercise bike is not intended for use by
persons with reduced physical, sensory, or
mental capabilities or lack of experience and
knowledge, unless they are given supervi-
sion or instruction about use of the exercise
bike by someone responsible for their safety.
4. Use the exercise bike only as described in
this manual.
5. The exercise bike is intended for home use
only. Do not use the exercise bike in a com-
mercial, rental, or institutional setting.
6. Keep the exercise bike indoors, away from
moisture and dust. Do not put the exercise
bike in a garage or covered patio, or near
water.
7. Place the exercise bike on a level surface
with at least 2 ft. (0.6 m) of clearance around
the exercise bike. To protect the floor or
carpet from damage, place a mat under the
exercise bike.
8. Inspect and properly tighten all parts each
time the exercise bike is used. Replace any
worn parts immediately.
9. Keep children under age 13 and pets away
from the exercise bike at all times.
10. Wear appropriate clothes while exercising;
do not wear loose clothes that could become
caught on the exercise bike. Always wear
athletic shoes for foot protection.
11. The exercise bike should not be used
by persons weighing more than 250 lbs.
(113 kg).
12. Be careful when mounting and dismounting
the exercise bike.
13. Always keep your back straight while using
the exercise bike; do not arch your back.
14. Over exercising may result in serious injury
or death. If you feel faint, if you become short
of breath, or if you experience pain while
exercising, stop immediately and cool down.
15. This Class B digital apparatus complies with
Canadian ICES-003.
16. Dispose of batteries in accordance with all
local codes and ordinances.
IMPORTANT PRECAUTIONS

4

5
Seat
Resistance Knob
Seat Handlebar
*Water bottle is not included
Water Bottle Holder*
Pedal/Strap
Leveling Cap
Console
Handlebar
Backrest
Thank you for selecting the WESLO®PURSUIT G 3.1
exercise bike. The PURSUIT G 3.1 exercise bike
provides a selection of features designed to make your
workouts at home more effective and enjoyable.
For your benefit, read this manual carefully before
you use the exercise bike. If you have questions after
reading this manual, please see the front cover of this
manual. To help us assist you, note the product model
number and serial number before contacting us. The
model number and the location of the serial number
decal are shown on the front cover of this manual.
Before reading further, please familiarize yourself with
the parts that are labeled in the drawing below.
BEFORE YOU BEGIN
Length: 4 ft. 4 in. (132 cm)
Width: 1 ft. 11 in. (58 cm)

6
M10 x 65mm Bolt (28)–2
M8 x 55mm Screw (46)–2 M8 x 80mm Bolt (39)–2
M8 x 20mm
Screw (40)–7
M6 x 20mm
Screw (47)–4
M6 x 40mm Screw (44)–4
M10 Locknut
(45)–2
M8 Locknut
(35)–2
M4 x 19mm
Screw (27)–2
M4 x 13mm
Screw (42)–4
PART IDENTIFICATION CHART
Use the drawings below to identify the small parts needed for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the
key number is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it
has been preassembled. Extra parts may be included.

7
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you complete all assembly steps.
• Left parts are marked “L” or “Left” and right parts
are marked “R” or “Right.”
• To identify small parts, see page 6.
• In addition to the included tool(s), assembly
requires the following tools:
one Phillips screwdriver
one adjustable wrench
Assembly may be easier if you have a set of
wrenches. To avoid damaging parts, do not use
power tools.
ASSEMBLY
2. Attach the Rear Stabilizer (15) to the Seat Frame
(2) with two M10 x 65mm Bolts (28) and two M10
Locknuts (45).
15
45
28
2
2
1
1. Go to iconservice.ca/CustomerService/
registration and register your product.
• activates your warranty
• saves you time if you ever need to contact
Customer Service
• allows us to notify you of upgrades and offers
Note: If you do not have internet access, call
Customer Service (see the front cover of this
manual) and register your product.

8
3
3. Attach the Seat Frame (2) to the Frame (1)
with four M8 x 20mm Screws (40); start all the
Screws, and then tighten them.
2
1
40
4. Orient the Seat Carriage (4) and the Handlebar
(5) as shown.
Attach the Handlebar (5) to the Seat Carriage
(4) with two M8 x 80mm Bolts (39) and two M8
Locknuts (35).
4
35
39
5
4
5. Attach the Seat (6) and the two Seat Supports
(48) to the Seat Carriage (4) with four M6 x
20mm Screws (47); start all the Screws, and
then tighten them.
56
4
47
48

9
6. Insert the pin on the underside of the Seat
Carriage (4) into the desired adjustment hole in
the Seat Frame (2).
Attach the Seat Carriage (4) to the Seat
Frame (2) with the Carriage Plate (31) and two
M8 x 55mm Screws (46).
6
31
4
2
46
7
7. Attach the Backrest (7) to the Seat Carriage (4)
with four M6 x 40mm Screws (44); start all the
Screws, and then tighten them.
44
7
4
44
8
13
27
49
8. Attach the Water Bottle Holder (13) to the
Upright (3) with two M4 x 19mm Screws (27).
Then, orient the Upright Cover (49) as shown
and slide it onto the Upright (3).
3

10
9
40 40
49
33
3
A
A
1
9. Have a second person hold the Upright (3) near
the Frame (1).
Locate the wire tie (A) in the Upright (3). Tie
the lower end of the wire tie to the Reed Switch
Wire (33). Next, pull the upper end of the wire tie
until the Reed Switch Wire is routed through the
Upright.
Tip: To prevent the Reed Switch Wire (33)
from falling into the Upright (3), secure the
Reed Switch Wire with the wire tie (A).
Tip: Avoid pinching the Reed Switch Wire
(33). Slide the Upright (3) onto the Frame (1).
Attach the Upright (3) with three M8 x 20mm
Screws (40); start all the Screws, and then
tighten them. Then, slide the Upright Cover (49)
downward and press it into place.
Avoid pinching
the Reed Switch
Wire (33)
10. The Console (8) can use two AA batteries (not
included); alkaline batteries are recommended.
Do not use old and new batteries together or
alkaline, standard, and rechargeable batter-
ies together. IMPORTANT: If the Console has
been exposed to cold temperatures, allow it
to warm to room temperature before insert-
ing batteries. Otherwise, you may damage
the Console or other electronic components.
Remove the battery cover from the back of the
Console (8), and insert batteries into the bat-
tery compartment (B). Make sure to orient the
batteries as shown by the diagram inside the
battery compartment. Then, reattach the bat-
tery cover.
10
8
B