ICP DAS USA DNP-211 User manual

P1
DNP-211 Quick Start
v1.0, Oct 2021
Packing List
In addition to this guide, the package includes the following items:
DNP-211
Screw Driver
CA-0910
A microSD card and a
micro SD/SD adapter
Technical Support
[email protected]
www.icpdas.com
Resources
How to search for drivers, manuals and
spec information on ICP DAS website.
For Mobile Web
For Desktop Web
DNP
-211-S
DNP
-211

P2
1 Connect to PC, Internet, IED and Power
Step1. Connect PC and DNP3 slave (IED) to LAN1 of DNP-211
with Ethernet switch.
Step2. Provide +10 ~ +48 VDC power to DNP-211.
2 Execute DNP-211 Utility to set DNP-211
Step1. Input IP address and port
to configure Modbus TCP
of DNP-211.
Step2. Configure Com port baud
rate and data format of
DNP-
211 (these setting
only for DNP3 485, if
useless, please don’t
care these Com port
setting).
S
tep3. Set DNP3 master ID and
Modbus slave ID of
DNP-211, and then select
DNP3 slave amount that
want to connect.

P3
3 Configure DNP3 Slave
Step1. Click the tab page of configured slave.
Step2. Select connection mode (TCP, UDP and Serial).
Step3. Input IP address or select Com port follow the connection
mode.
Step4. Input DNP3 slave ID, can’t be the same as the DNP3
master.
Step5. Click “Set” button to start the I/O configure.
4 DNP3 Slave I/O Configure
Step1. Select the I/O Type or Group_Variation (I/O Type and
Group_Variation are linkage settings).
Step2. Input start channel index in “Start Index” of the I/O.
Step3. Input I/O amount in “Amount” of the I/O to be monitored.
Step4. Select output mode if the I/O Type is output I/O.
Step5. If necessary, you can fill in some user-friendly
annotations in the “Description” field.
Step6. Click “Add” button to add a new I/O configuration field.

P4
5 Exports and Upload Configuration
Step1. After repeating operations at points 3 and 4 and
completing the I/O settings, you can press the “Modbus
Map” button to output the I/O Modbus register address.
Step2. Click “Export” button to export the configuration file.
Step3. Click “Upload” button, input the DNP-211 IP address
(factory default is 192.168.0.1).
Step4. Select the configuration file that just exported to upload.
Step5. Reboot the DNP-211; the DNP-211 will enable the new
configuration file.
6 Read and Test
Step1. Execute “DNP-211 Reader” and import configuration file.
Step2. Click “Connect” to start to read data from DNP-211
modbus register.