T2 Wall Mount Installation
Feed your computer monitor cords and any other cords
down through the opening in the wall mount - passing
through the bearing.
Note: When measuring for the length of the cords, be
sure to allow enough extra cord to accommodate the tilt
and rotation of the monitor.
Front arm
Monitor
mount
Back arm
Do not disassemble these bearing packs.
1
2
3
Note: The wall mount
is shipped with the
bearings wrapped and
it is recommended that
you leave the wrapping
on until later in the
installation process. Wall Mount
Locate a stud in the wall you intend to mount your arm on
and remove the wall mount from the box. Mark the top hole,
drill 11/64 pilot hole and insert an ICW provided #14 screw
and tighten slightly. Using a level, mark the two lower holes
and drill pilot holes, insert the last two #14 screws and, with
the mount level, tighten all screws securely.
Note: ICW supplies #14 wood screws. If installing onto
metal studs you will need to replace with proper metal stud
fasteners. All hardware used to secure wall mount must have
a properly countersunk head.
