ICW EV65 User manual

Screw in the VESA inter ace plate into
the VESA hole pattern on the back o your
LCD monitor using the our 4mm phillips
screws provided.
Slide the rails into the EV65 joint.
(2) VESA plates
(1 ) Wall plate w/ track
(2) EV65 track sliders
(2) 1 4x2 1 /2"
wood screws
(2) 1 0-32x1 /4 sockethead
cap screws
(4) 4mm phillips screws
(2) 5/1 6-1 8x3/4L sockethead
cap screws
(1 ) 1 /4" hex key
(1 ) 5/32" hex key
Dual monitor EV65 wall mount
Bolt the rails into place using the two
5/1 6-1 8x3/4L sockethead cap screws
provided with the 1 /4" hex key provided.
Installation instructions for the EV65 dual monitor wall/track mount - page 1 II001 - 10/19/2009 - MF
Page 1

A ter locating a wall stud and by using a
level, mark the holes or the wall place.
Create guide holes be ore screwing in the
countersunk 1 4x2 1 /2 wood screws
provided.
A ter loosening the slider plate on the
EV65, slide on to the track like shown in
the illustration. Once on, tighted the slider
place by using the indexing chrome
handle on the slider. Do this with both
monitors.
Once you have both monitors on the
track, locate the track endcaps in your
hardware bag. These will it into each end
o the track, covering the sharp edges.
Using the two 1 0-32x1 /4 sockethead cap
screws provided, asten the track endcaps
to the track like shown with the 5/32" hex
key.
Dual monitor EV65 wall mount Page 2
Installation instructions for the EV65 dual monitor wall/track mount - page 2 II001 - 10/19/2009 - MF