IDEAL Networks LanTEK IV User manual

LanTEK IV
Field Software Update Procedure
Proof of Performance

2www.idealnetworks.net 163818. Rev 1.
NOTE:
This update erases all user data, SYNC your LanTEK IV to AnyWARE Cloud
before performing the update.
From the home screen, press
then upload to AnyWARE Cloud from the SYNC prompt.
1. Download the software:
Download the software from: www.idealnetworks.net/support/downloads/
Format a USB stick of between 4 and 32GB on Windows PC (Fat32 format)
Extract the files from the ZIP to the ROOT of USB flash drive with >3GB free space.
These files should be on the ROOT (not inside a folder) of the USB flash drive.
The contents of the flash drive should be similar to this:
Software ZIP file
Extracted files

3
Proof of Performance
2. Update main handset:
• Power o LanTEK IV
• Disconnect any test adapters from the LanTEK IV
• Connect main handset to DC power adapter
• Connect USB flash drive to main handset
• Power on main handset and wait for the following screen:
USB
Power
• Press and hold the
button to start the update process.
Release the button when the percentage
indicator is shown on the screen
• This stage will take a few minutes to
complete
• During this stage the screen will show the
update progress (right):

USB
Power
When complete, it will show this message:
• Press the power button to restart the
handset and complete the update procedure.
After a few seconds LEDs at the top of the
display (Partner & Hazard) will flash Green /
Red indicating update is continuing and the
following screen will be shown (right)
• Press and hold the power button for 15
seconds
• Release the power button to shut
down the handset
• Remove the flash drive
• This will take several minutes, after which the
update is complete and the main handset is
ready for use
4www.idealnetworks.net 163818. Rev 1.

5
Proof of Performance
3. Update remote handset:
• Power the remote handset OFF
• Disconnect any test adapters from the LanTEK IV
• Connect DC power adapter to the remote handset
• Connect the USB flash drive to the remote handset
• Power on the remote handset then after a few seconds Tone and Talk LEDs will
alternately flash green, then just the tone LED will remain steady green:
USB
Power
• Press and hold the button to start the
update process. This stage will take a few
minutes to complete
• During this stage the Tone and Talk LEDs
will flash green
• When the first stage of the update is
complete, the Pass LED will remain steady
green:
• Press and hold the power button for 15
seconds
• Release the power button to shut down
the handset
• Remove the USB flash drive
• Press power button to turn on the
handset to continue the update
• The Tone and Talk LEDs will flash red/
green during this process:
• This will take several minutes, after which the
Tone Talk LEDs will stop flashing indicating
the Remote handset is ready for use