IFM Electronic Efector200 OGS50 Series User manual

Operating instructions
Through-beam sensor
OGS50x
OGE50x
UK
704071 / 01 02 / 2008

2
1 Functions and features
The through-beam sensor detects objects and materials without contact and
indicates their presence by a switching signal.
For the range see the type label.
2 Installation
transmitter receiver
Install the receiver (OGE...) and secure it to a bracket.►
Align the transmitter (OGS...) to the receiver and fix it.►
3 Electrical connection
Disconnect power.►
Connect the unit as follows.►
Transmitter
Cable Connector Pin connection
L+ BN pin 1
L- BU pin 3
— — pin 4
— — pin 2
Core colours BN = brown, BU = blue, BK = black
Receiver
Cable Connector Pin connection
L+ BN pin 1
L- BU pin 3
load BK pin 4
— — pin 2
Core colours BN = brown, BU = blue, BK = black

UK
3
4 Operating and display elements
transmitter receiver
�
  
LED1:
[OUT off]2:
[OUT on]3:
4 Settings
4.1 The receiver is to switch when the object is detected
1
Position the object.►
receiver transmitter
Press [OUT on] for 2 s.►
The sensitivity is set to the object.>
The LED flashes.>
2
Remove the object.►
receiver transmitter
Press [OUT off].►
The sensitivity is set without object.>
The LED goes out. The programming is finished.>
4.2 The receiver is not to switch when the object is detected
Position the object (see figure 1) and press [OUT off] for 2► s.
Remove the object (see figure 2) and press [OUT on].►

4
The settings can also be carried out first without object (step 1) and then with
object (step 2).
4.3 Programming unsuccessful
LED flashes quickly, 8 Hz.>
Possible causes
Insufficient difference in measurements.•
Max. programming time of 15 min. exceeded.•
4.4 Setting of maximum sensitivity
Align the receiver so that no light is received.►
The receiver is to switch when the object is detected.
First press [OUT on] and then [OUT off].►
The receiver is to switch when the object is not detected.
First press [OUT off], then [OUT on].►
4.5 Locking or unlocking the buttons
The unit can be locked electronically to prevent unintentional settings.
Press [OUT on] and [OUT off] simultaneously for►
10 s.
Acknowledgement is indicated by a change of the>
LED status.
5 Operation
Check whether the sensors operate correctly.►
The receiver LED lights when the switching output is switched.>
6 Maintenance
Keep the lenses of the sensors free from soiling.►
For cleaning do not use any solvents or cleaning agents which could damage►
the plastic lenses.
Technical data and further information at www.ifm.com