In-situ RDOX User manual

Getting Started
Box Contents
Tools, Supplies, & Accessories (Not Included)
• RDOX instrument (stainless steel or plastic)
• RDO cap
Install RDO cap.
1
• Flathead & Phillips head screwdrivers
• Wire cutters
• 7300 monitor or other monitor
Wire RDOX instrument to monitor.2
Connect RDOX to Twist-
Lock cable. Twist cable
until it clicks into place.
Insert ying leads cable
through cable gland cap.
Identify brown and white
cables. Cut these unused
wires close to their base.
Ensure monitor is
isolated. Remove cover.
Unscrew cable gland cap.
Isolate the monitor from power before moving forward. There is a risk of electrical shock if you
do not isolate the monitor before installing wires.
2023-11-08 | 2000212
RDOX Quickstart Guide
Remove red dust cap.
Unscrew and remove
nose cone from the
instrument.
Remove the RDO cap
from the storage canister.
Align RDO cap’s at edge
with instrument’s at
edge. Slide on cap.
Replace the nose cone.
Align
with cap

Connect the blue cable where the terminal is labeled“white”when wiring cable into plug.
Screw on monitor cover.
Connect power to
monitor.
Insert red, black, blue,
green wires into plug.
Screw in. Insert terminal
plug into terminal block.
Tighten cap securely
onto cable gland
locknut.
Thread wires through
cable gland opening.
Remove terminal plug
from terminal block.
Connect power to
monitor. Press Menu.
Use arrow keys to select
Add Sensor. Press OK.
Use arrow keys to select
Sensor Cong. Press
OK.
When RDOX appears,
select it. Press Menu
twice to access data.
3Add RDOX readings to 7300 monitor.
Calibrate RDOX instrument.4
Repeat above to install more sensors. An expansion box is required for more than 2 sensors.
10
Clean sensor with a soft
cloth.
Press Menu.Moisten a sponge and
place it in a dark cup.
Put instrument in cup.
Allow it to humidify for
up to 5 minutes.
www.in-situ.com

Learn More
View additional specications, compliance information, and detailed instructions at www.in-situ.com.
If the equipment is used in a manner not specied by the manufacturer, the protection
provided for the equipment may be impaired.
Intended Use
The RDOX is designed to be safe in these conditions:
Safety
• Operable temperatures of 0° to 50° C (32° to 122° F).
11
Read the safety information on this page before using the RDOX. If you have questions, contact
In-Situ technical support for assistance.
To clean the instrument, use a soft cloth and mild detergent. Keep the nose cone and RDO cap
on. Do not use organic solvents because they may damage the RDO cap.
• Only suitably qualied personnel or competent persons may install, operate, or repair this equipment.
• Check that the sensor has been terminated correctly. Incorrect termination may cause damage to the
instrument or monitor.
• Sensors need to be correctly addressed to the monitor before use.
Use the arrow keys to
select Measurement
Cong and press OK.
Select DO saturation
and press OK.
Select Calibrate and
press OK.
Press OK to begin
calibration. Press OK
when the value stabilizes.
www.in-situ.com