In-situ Aqua TROLL 600 User manual

Aqua TROLL 600 Quickstart Guide
11-970-498-1500 www.in-situ.com
Box Contents
1 Documentation and software
2 Wiper motor and brush/wiper
3 Aqua TROLL 600 sonde
4 Water quality sensors (2 of 4)
5 Water quality sensors (2 of 4)
6 RDOsensor cap
7 Accessory supplies
8 pH/ORPsensor maintenance supplies
9 Extra sensors
10 D-cell alkaline batteries
11 Instrument tools
Getting Started
1 Install the batteries.
2 Install the wiper motor and sensors.
Open the battery
compartment.
Install alkaline batteries. Use Allen wrench to
remove and check
desiccant color. If pink,
replace.
Remove restrictor and
protective sticker.
Remove dust cap from
wiper motor or motor
port plug.
Apply lubricant to
O-rings.
Insert motor/port plug
into center port.
Close battery
compartment. LCD
screen should activate.

21-970-498-1500 www.in-situ.com
Remove dust cap from
pH/ORP sensor.
Tighten screw at base of
each sensor with Allen
wrench.
Apply a pea-sized drop of
lubricant to O-rings.
Replace restrictor with
vent holes at base of
instrument.
Install sensor in port
1. Sensor tongue must
slide into blue interlock
groove.
Install remaining sensors.
3 Connect a cable to the instrument.
Remove protective caps
from instrument and
cable.
Ensure O-ring on
instrument connector
is clean. Apply vacuum
grease to O-ring.
Flat edge inside cable
end must align with
at edge on instrument
connector.
Hold textured sleeve of
cable in one hand and
instrument in other. Push
and twist until click.
When using a conductivity sensor and turbidity sensor together, install them side-by-side to
maximize performance.

31-970-498-1500 www.in-situ.com
4 Connect the communication device.
If desiccant is present,
remove it from cable.
Align TROLLCom
connector with cable
end. Push and twist until
click.
Connect VuSitu directly
to instrument. Hold
sonde vertically with
sensors up. Screen will
activate.
or
5 Connect to the software.
iOS Android
An iOS device
automatically connects
to the closest In-Situ
instrument.
To connect to another
instrument, press
Disconnect and then
Choose or Add Device.
VuSitu displays a list of
available connections.
a b
You must have the VuSitu mobile app to use the instrument with a mobile device. Download
VuSitu from the Google Play Store or the Apple App Store.
Tap your mobile device’s
back button to return
to VuSitu. Then tap the
PowerPack to connect.
VuSitu will display the
Connected Instrument
screen when pairing is
complete.
c d
Launch VuSitu and tap
Bluetooth Settings.
Tap Pair new device.
Select the PowerPack
that matches your In-Situ
device’s serial number.
ab

41-970-498-1500 www.in-situ.com
6 Learn more.
Get complete instructions about calibration, logging and working with data in the product manual.
Download it from www.in-situ.com.