INNOVAPLAS Lumi-O H2O 7000 User manual

H2O WITH SELF-LATCHING 9600
Sand
20 lbs
Sand
Contents of the ladder box SKU # 7000
Contents of the Self-Latching box SKU # 9600
(not included)
Wet side
(#7000)
Dry side
(#9600)
A
SCREW KIT 140-0010
x2
x2
x2
x1
(³⁄4 IN.)
x4
A
Required tools (not included)
A weather-resistant padlock is
recommended.
Maximum functional
width of 1/4 inch.
Phillips #2 Phillips #3
7/16 wrench
Phillips bit
REV. 10/27/2020 PN: PG:1
2257 route 139
Drummondville, Québec
J2A 2G2
1 year on step and closure.
1 year on hardware.
MANUFACTURER WARRANTY
WWW.INNOVAPLAS.COM
1) Install the posts in the H2O step
as far as they go and secure in
place with the screws provided.
2) Slide the platform onto the
posts but do not secure.
x4
A
Security straps
x2
x2 x2
(3/4 IN.)
x12
(2 1/2 IN.)
x2
SCREW KIT 140-0016
(2 1/2 IN.)
BC A D
x2
x4
x3
WARNING
Install the step on a flat surface.
Do not jump or dive from the step or ladder.
Remove the step from water when temperatures drop below freezing.
In winter, the step should be stored in an area protected from snow.
Never lift the step by its handrails.
Use BATTERY operated tools to avoid electric shock near water.
Ensure no corrosive materials are added to the step or harware kit.
The step must be installed per manufacturer’s instructions.
File off all stripped or sharp edges before assembly to avoid injuries
and liner damage.
The manufacturer is not responsible for damages or injuries caused
by improper installation or use of product.
To ease the installation of handrails and bolts, use a screwdriver to
line up the holes.

BC
D
1) Insert the two handrails over the
two front posts. Do not secure yet (the
handrails will more than likely slide down
the posts to rest on the platform).
1) Fill the two bags provided with 10 lbs of
sand each.
2) Insert the sand bags into the bottom of
the H2O before submerging the step.
1) Slowly submerge the
step into the pool. Make
sure you do not damage
the pool liner in the
process.
2) Leave a ½"-1" gap
between back of the
ladder and the pool liner.
E
REV. 10/27/2020 PN: PG:2
2257 route 139
Drummondville, Québec
J2A 2G2
1 year on step and closure.
1 year on hardware.
MANUFACTURER WARRANTY
WWW.INNOVAPLAS.COM
Sand
10 lbs
Sand
10 lbs
Caution Max: ½”-1”
Securiy strap
1) Once the step is in the
pool, secure the platform
to the top seat (see
illustration) using the two
straps provided.
OPTIONAL:
Once the pool step has been
completely assembled and
secured to the pool, attach the
2 screws supplied through the
platform to the top seat of your
pool to provided a more rigid
assembly.
x2
wet side
dry side
x2
B
H2O WITH SELF-LATCHING 9600
F H
1) Insert the two posts into
the rear holes of the step.
2) Force the posts to a
vertical position flush with
the rear surface and
secure in place with the
bolts and nuts provided.
3) Insert the post covers.
x2
x2
C
D
1) Slide the Self-Latching
posts through the
platform and small
handrails.
2) Secure the platform
using the screws
provided.
3) Secure the small
handrails to the posts
with the screws provided.
4) Insert the four post
covers on the handrails.
x12
A
WARNING
LOCK THE DOOR TO THE STEP
WITH A PADLOCK WHEN THE
POOL IS NOT IN USE TO
PREVENT DROWNING AND
UNAUTHORIZED ENTRY.