
REV. 01/30/2020 PN: PG:2
2257 route 139
Drummondville, Québec
J2A 2G2
WWW.INNOVAPLAS.COM
BC
1 year on step and closure.
1 year on hardware.
MANUFACTURER WARRANTY
D
E
F
BILTMOR 5015 WITH SELF-LATCHING 9600
x13
1) Insert the two large posts and the 35”
post into the post ends and secure
them in place with the screws provided
(see medallion).
2) Insert the platform over the two rear
posts.
3) Insert the small and large handrails
as illustrated. Secure the large handrail
with the screws provided. Leave the
small handrails floating.
4)
Fasten the access panel with the screws
provided.
D
’3
1/4
’
1/4”
align screws from
center of plate
x2
x3
D
E
Sand
15 lbs
Sand
15 lbs
1) Insert 2 15 lbs (7 kg)
sand bags on either side of
the third step, as shown.
1) Slowly submerge the step into
the pool. Make sure you do not
damage the pool liner in the
process.
2) Angle the whole step so that it
is entirely under water. Purge all
the air from under the step.
Security strap
1) Once the step is in
the pool secure the
platform to the top
seat (see illustration)
using the two straps
provided.
x2
OPTIONAL:
Once the pool step has been
completely assembled and
secured to the pool, attach the
2 screws supplied through the
platform to the top seat of your
pool to provided a more rigid
assembly.
x2
F
1) Snap the three post ends into the
step, making sure that the cylindrical
part is vertical and that the ends are
snapped properly in their respective
housings.
2) Snap the filler post end into the step
as shown.
3) Snap the two feet to the bottom of
the step.
FILLER
35” post
G H
1) Insert the two posts into
the rear holes of the step.
2) Force the posts to a
vertical position flush with
the rear surface and
secure in place with the
bolts and nuts provided.
3) Insert the two post
covers.
x2
x2
G
C
x12
1) Slide the Self-Latching
posts through the
platform and small
handrails.
2) Secure the platform
using the screws
provided.
3) Secure the small
handrails to the posts
with the screws provided.
4) Insert the four post
covers on the handrails.
D