INNOVAPLAS Lumi-O ELEGANT 1002-HRK User manual

ELEGANT WITH DECK
Sand
30 lbs
(not included)
Sand
Contents of the Accessory box SKU # 1002-HRK
x32
(¾ IN.)
x2
x2
x2 x4
SCREW KIT 140-0006
(2 IN.)
x8 x8 x4 x4
(2 ½ IN.)
Required tools (not included)
A
1) Assemble the tubes to the step with the screws,
washers and nuts provided.
2) Slide the lateral supports over the posts.
Step Shell
AB C D E
Phillips #2
Phillips #3
7/16 wrench
Phillips bit
x4
x8
x4
E
C
D
REV. 03/06/2020 PN: PG:1
2257 route 139
Drummondville, Québec
J2A 2G2
1 year on pool step.
1 year on hardware.
MANUFACTURER WARRANTY
WWW.INNOVAPLAS.COM
WARNING
Install the step on a flat surface.
Do not jump or dive from the step.
Remove the step from water when temperatures drop below freezing.
In winter, the step should be stored in an area protected from snow.
Never lift the step by its handrails.
Use BATTERY operated tools to avoid electric shock near water.
Ensure no corrosive materials are added to the step or harware kit.
The step must be installed per manufacturer’s instructions.
File off all stripped or sharp edges before assembly to avoid injuries
and liner damage.
The manufacturer is not responsible for damages or injuries caused
by improper installation or use of product.
To ease the installation of handrails and bolts, use a screwdriver to
line up the holes.
inside step

B
C
1) Drop the ballasts in the step
holes.
2) Insert the rear posts into the
lateral supports.
3) Insert the handrails over the
two front posts. Mark on the
rear posts with a pencil where
to cut posts so that they fit in
the handrails.
4) Cut the posts.
D
1) Secure the lateral supports and the handrails to
the posts using the screws provided.
2) Secure the lateral supports to the deck using the
screws provided.
x8
Sand
30 lbs
1) Fill the ballast
with sand. The
approximate weight
should be 15 lbs
per ballast.
Align holes
2) Screw the lid in place
and align the cover ribs
with the holes in the
ballast base.
3) Fasten the cover to the
ballast base with the four
screws provided.
x8
B
4) Slowly submerge the
step into the pool. Make
sure you do not damage
the pool liner in the
process.
5) Angle the whole step
so that it is entirely under
water. Purge all the air
from under the steps.
6) Slide the lateral
supports to the height of
the deck.
REV. 03/06/2020 PN: PG:2
2257 route 139
Drummondville, Québec
J2A 2G2
1 year on pool step.
1 year on hardware.
MANUFACTURER WARRANTY
WWW.INNOVAPLAS.COM
x24
B
A
ELEGANT WITH DECK