INNOVAPLAS Lumi-O H2O 7000 User manual

REV. 10/22/2020 PN: PG:1
1 year on step and deck kit.
1 year on hardware.
MANUFACTURER WARRANTY
WARNING
Install the step on a flat surface.
Do not jump or dive from the step.
Remove the step from water when temperatures drop below freezing.
In winter, the step should be stored in an area protected from snow.
Never lift the step by its handrails.
Use BATTERY operated tools to avoid electric shock near water.
Ensure no corrosive materials are added to the step or harware kit.
The step must be installed per manufacturer’s instructions.
File off all stripped or sharp edges before assembly to avoid injuries
and liner damage.
The manufacturer is not responsible for damages or injuries caused
by improper installation or use of product.
To ease the installation of handrails and bolts, use a screwdriver to
line up the holes.
H2O 7000 WITH DECK KIT 0005
Required tools (not included)
(not included)
Sand
Contents of the H20 SKU # 7000
SCREW BAG 140-0010 SCREW BAG 140-0011
Contents deck kit SKU # 0005
1) Install the posts in the step as
far as they go and secure in place
with the screws provided.
2) Slide the deck arms over the
posts but do not secure.
x2 x2
x2
x1
(³⁄4 IN.)
x4
A
x2
x2
x2
x2
(1 ¹⁄2 IN.)
(³⁄4 IN.)
x16 x16
A B
Sand
20 lbs
Phillips #2
Phillips bit
A
x4
A
2257 route 139
Drummondville, Québec
J2A 2G2
WWW.INNOVAPLAS.COM

REV. 10/22/2020 PN: PG:2
H2O 7000 WITH DECK KIT 0005
1 year on step and deck kit.
1 year on hardware.
MANUFACTURER WARRANTY
1) Insert 2 10
lbs sand bags
into the bottom
of the ladder. 2) Insert the ladder
into the pool.
Leave a ½”-1“ gap
between back of
the ladder and the
pool liner.
Caution Max: ½”-1”
1) With the ladder in the pool, make
sure the deck arms are straight and
parallel to each other. Trace the hole
profile of both deck supports onto the
deck. Measure to make sure the
center to center distance is 22 ¼''.
2) When done tracing, swing the deck
supports to the side so that the traced
profile is visible to install the metal
brackets.
1) Install the rear posts so that
the ends with the small hole are
closest to the deck. Secure to the
metal brackets with the screws
provided.
2) Secure both deck supports
with the screws provided.
1) Slide the handrails over
the posts as shown.
2) Take a pencil and mark
where the handrail ends
on the rear posts.
3) Remove the handrails
and cut the top off the
posts at the traced line.
1) Secure the deck
supports to the front
posts using the
screws provided.
2) Slide the handrails
on the posts and
insert all 4 end caps
on the handrails
before securing them.
3) Secure the
handrails in place
with the screws
provided.
BC
D
F
E
G
Sand
10 lbs
Sand
10 lbs
x4
B
x4
A
x8
A
1) Secure the two metal
brackets centered in the
traced profile to the deck
using the screws provided.
2) Lower the deck supports
over the brackets.
2257 route 139
Drummondville, Québec
J2A 2G2
WWW.INNOVAPLAS.COM
22 1/4''
A
B
x12
B