inohom Smart Touch Switch 1 User manual

Smart Touch Swtch 1
(STS1710)
V1.0
inohom
USER MANUAL
EN
Smart Life Solutions

1: Important Safety Information
2: Description and Properties
3: Technical Properties
3.1: Technical Details
3.2: Technical Drawing
4: Installation
4.1: Before Installation
4.2: Mechanical and Electrical Assembly
4.2.1: Return to Factory Settings
4.2.2: Electrical Assembly
4.2.3: Mechanical Assembly
5: Communication Properties
6: Button Functons
7: Commissioning
8: Regulations
3
4
4
4
5
5
5
6
6
6
7
8
9
10
11
Content

3
1: Important Safety Informaton
ELECTRIC SHOCK DANGER!
Do not open the product!
Please read ths manual before usng the devce!
Not followng the recommendatons n ths manual mght lead to danger.
The manufacturer GST ELEKTRONİK LTD ŞTİ cannot be hold responsble
for any loss or damagesarsng from not followng the nstructons n ths user manual.
Devce s no longer under warrant after faults arsng n these cases.
The devce s desgned to control other electronc devces and operates n houses.
Incorrect connecton or usage mght cause fire or electrc shocks.
There mght be voltage on the connecton tps even f the devce s turned off.
The fuse or power source must always be dsabled f the connectons wll be changed.
Do not operate the devce wth wet or most hands to avod electrc shock rsk.
Do not make any changes on ths devce that are not specfied n the user manual.
Do not leave the devce drectly exposed to sunlght or other heat sources. Do
not place the devce near open fire or ntense heat sources such as electrc
Other devces
The manufacturer GST ELEKTRONİK LTD. ŞTİ. cannot be held responsble for
any damages or out-of-warranty f any unsutable connectons other than the
connectons expressed n the connecton manual are made wth other devces.
Ths product s desgned only for ndoors use n a dry envronment.
Do not use the product n wet or damp envronment such as bathtub, snk,
bath and pool.
Devce Cleanng
Heat Sources and Fre
Do not clean the product wth solvent (thnner, gasolne, acd etc.) or
abrasve cleanng products. Avod cleanng wth vapour cleanng tools.
heater.

2: Descrpton and Propertes
3: Techncal Propertes
3.1: Techncal Detals
İnohom Smart Touch Swtch 1 (STS1710) enables llumnaton, on/off control
and scenaro actvaton management. The product has 1 programmable
touchscreen button.
There are black and whte glass colour optons.
The product has 1 bult-n 16A 277V~ Relay output. Usage wth or wthout relay s
possble. Ths product can be mounted to standard swtch cases. The product has
tempered glass desgn and touchscreen LED buttons.
Power Consumpton
Supply Voltage
Desgn
1.2W (Max)
12VDC or 100-240VAC
4mm Tempered Glass Surface
1 Relay (277VAC 16A nrush 100A)
Capactve Touchscreen
RF 433 Mhz
nohom OS
2.5mm² screwed electrc termnal
IP 20
0 - 50°C
Max 50°C %65 Ambent Humdty
Max 2000m
90mm x 90mm x 14mm
Surface Wall Mountng
EN55032:2015, EN55024:2011, EN62368-1
Outputs
Buttons
Communcaton
Operatng System
Connectons
Protecton Class
Operatng Temperature
Heght
Relatve Humdty
Dmensons
Installaton
EMC Standards
4

3.2: Techncal Drawng
90mm 14mm
20mm
25mm
35mm
90mm
5
mm
0 5 10 15 20 25
4: Installaton
4.1: Before Installaton
Unsutable connectons aganst the manual mght cause health, lfe or materal
damage rsk.
- Do not power on the devce before all the connectons are completed.
- Check the devce user manual to create a secure connecton.
- Do not make any connectons other than the connectons specfied n the scheme.
- Do not connect wth devces that do not comply wth securty standards.
Mount the devce away from metal surfaces or objects to avod any negatve
mpact on the wreless communcaton performance.

4.2: Mechancal and Electrcal Assembly
4.2.1: Return to Factory Settngs
4.2.2: Electrcal Assembly
L N
Wth relay group that can be mounted at the back of the devce, you can make
varous on-off controls over Smart Touch Swtch 1. The relays are resstant up to
277VAC 16A nrush 100A and enables long-term use wthout relay adheson.
L : Phase
N : Neutral
Q : Dgtal
Output Pn
COM : Common
contact pont
+,- : Postve,
Negatve poles
A : Mountng
apparatus bearng
Q1
Devce; When the “R” and “G” contacts are kept n the short crcut poston for 10
seconds wth a conductve cable, t returns to the factory settngs.
+ -
12V
DC supply
p r o d u c t
connecton
structu re
6
L N
Q1
R T G
A A

The product mountng apparatus s desgned wth European standard flush
mounted box dmensons. The flush mounted box should be placed 120 cm above
Please avod overtghtenng the lower mountng screw.
the ground. Use the mountng apparatus n the box for mountng. Please use the
correspondng holes of mountng apparatus to mount swtch case. Make sure that the
apparatus s perpendcularly mounted to the ground. The holes on the mountng metal
sheet allows 20° devaton for fine tunng.
inohom
20° Fne
Tunng
Angle
4.2.3: Mechancal Assembly
7
C
C
BBB
B : Mountng Ear
C : Mountng Screw

5: Communcaton Propertes
inohom inohom
inohom
SMART TOUCH
SWITCH 1
SMART TOUCH
SWITCH 1
WEB
RF 433 Mhz
inohom
CCM176X
16A
COM1
COM2
COM3
COM4
COM5
COM7
COM6
Q1
Q0
Q6
Q7
I 0
I 1
I 2
I 3
I 4
I 5
I 6
I 7
I 15
I 14
I 13
I 12
I 11
I 10
I 9
I 8
Q15
Q14
Q13
Q12
Q11
Q10
Q9
Q8
12V
+ -
Q5
Q4
Q3
Q2
COM0
10A
inohom
RL 1710
NOVA PANEL
MOBILE
CCM 176X
The devces use nohom communcaton protocol. Smart Touch Swtch 1 can
wrelessly communcate wth other nohom products and can learn and change output
The product can be optonally used wth or wthout relay.
SWITCH
Other devces
ntegrated va IP
Camera, Intercom, EIO
8
and state values of other products.
nohom IP Gateway devces (Nova Panel/Home Manager) enable managng other
devces ntegrated to the automaton va the nternet by enablng the system to
communcate on IP layer.

nohom Smart Touch Swtch seres swtch buttons can be assgned wth dfferent
tasks. The tasks assgned to the buttons are adjusted by nohom authorzed dealer.
6: Button Functons
Ths operaton s completed by traned techncal personnel n commssonng program.
Illumnaton
On-Off
Scenaro
Actvaton
9

10
The commssonng of the nohom products after assembly s completed by the
authorzed nohom dealers and techncal staff. Detaled management panel
nterface ensured communcaton and other settngs between the devces.
At commssonng stage, the “FIND” button on the automaton control panel nterface s
used to dentfy the related devce.
The LEDs on the devce wll blnk wth 1 second nterval when pressed “FIND” button
and press “STOP” button when the devce s found.
Then, settng parameters are sent to the related devce wth “MATCH” button and the
devce becomes operatonal.
“IO TEST” buttons on the control panel nterface can be used for testng the correct
cable connecton of the devce. The state of the desred output can be changed as
on/off and energy flow towards the termnal s dentfied.
7: Commssonng

11
8: Regulatons
Legal Warnng
Declaraton of Conformty
GST Elektronk Elektrk Yazlm Makna Dan. San. Ve Tc. Ltd. St.
Kemaloz Mah. Degrmendere Cad. No:8/A 64100 Usak/Turkey
www.nohom.com
0090 850 811 82 83
nfo@nohom.com
The propertes, functonaltes and other product propertes can be changed wthout pror
notce. nohom reserves the rght to revew or update the products, software or documents
wthout any lablty to notfy any ndvduals or organzatons. İnohom s a trademark of
GST Elektronk Elektrk Yazılım Makna Dan. San. ve Tc. Ltd. Şt. All other brand and
product names heren are the trademarks of ther respectve owners.
The domestc producton logo on all the products show
that themanufacturng and software are 100% completed
n Turkey.
The company has ISO 9001 Qualty Management, 14001
Envronment Management, 45001 Occupatonal Health
and Safety Standards.
The devces tagged wth WEEE symbol shall not be dscarded wth other
domestc waste. The product should be delvered to the related collecton pont
for waste electrc and electronc equpment recycle.
CE mark s a free trademark only for authorzed officals and ths mark
does not contan any property assurance.
The product box s manufactured from a recyclable materal. Do not dscard the
package waste wth domestc or other waste and recycle package wastes.
9001:2015 14001:2015 45001:2018
Smart Life Solutions
This manual suits for next models
1
Table of contents
Other inohom Home Automation manuals