Integra Omni-Tract User manual

Integra®Omni‐Tract®
Speed‐Tract®SegmentedRingFrame


Instructionsforuse



® ®
®


1


SegmentedRingFrame
1.Toconnectthesegmentsoftheringinsertthe
screwsintotheopenendoftheframesegment.
Onceinplacesecurethesegmentsbytighteningthe
screwclockwise.
3

 
3.Torepositiontheendsofthesegmentedring
loosenthescrewbyturningthemcounterclockwise.
Moveframeendtotheappropriatepositionand
tighteninplacebyfollowingstepnumber1above.
2

 
2.Segmentsshouldallbesecuredbeforeattaching
theringtothesystemsupportarm.




Donotforciblytrytoremovetheentirescrewfrom
theframesegments.Thereisaretainingringadded
tomakesurethescrewstaysinpositionanddoesnot
getmisplaced.
Caution:

, USA
Integra, the Integra logo, Omni-Tract and Speed-Tract are registered trademarks of Integra LifeSciences Corporation or its subsidiaries in the United
States and/or other countries. ©2020 Integra LifeSciences Corporation. All rights reserved. 40-9030 Rev AAA 2020-09 1512329-2
©2020
European Representative
EC REP
Tel: [phone]
69800 Saint Priest – FRANCE
Integra LifeSciences Services