Interlogix TVD-5110-3 User manual

P/N 1072503B • ISS 18DEC12
TVD-5110-3 Dome Camera
Pocket Guide
Overview
This is the Pocket Guide for TVD-5110-3-P/ TVD-
5110-3-N Dome Camera. This guide describes a
standard installation.
The camera consists of the following:
• Camera with power and video output cable
Refer to the figures when performing the camera
setup procedures.

2
Figure 1: Parts of the camera
A. Video cable
B. Power cable
C. D/N sensor (Do not cover with the
shroud)

3
Figure 2: mounting sticker template (mm)

4
Installation
To install the camera:
1. Fasten the camera to a wall or ceiling (or another
solid surface). The camera must be stable when
connected.
2. Connect the 75 Ωcoaxial cable to the video
output.
3. Connect the power cable to the camera.
4. Adjust the camera position and angle as
required.
Specifications
Power supply 12 VDC ± 10% / 500mA
Current 50 mA
Power consumption 0.6 W max.
Operating temperature -10 to +50 °C (14 to 122°F)
Storage temperature -20 to70 °C (-4 to +158°F)
Weight 320 g (0.7 lb.)
Dimensions (H ×Ø) 60 x 100 mm (2.36 x 3.94 in.)

5
Contact information
For contact information, see www.interlogix.com or
www.utcfssecurityproducts.eu.
Regulatory information
© 2012 UTC Fire & Security Americas Corporation, Inc.
Interlogix is part of UTC Climate Controls & Security, a unit of
United Technologies Corporation. All rights reserved.
Trademarks and patents
The IFS name and logo are trademarks of United Technologies.
Other trade names used in this document may be trademarks or
registered trademarks of the manufacturers or vendors of the
respective products.
Manufacturer
UTC Fire & Security Americas Corporation, Inc.
2955 Red Hill Avenue, Costa Mesa, CA 92626 5923, USA
Authorized EU manufacturing representative:
UTC Fire & Security B.V.
Kelvinstraat 7, 6003 DH Weert, The Netherlands
FCC compliance
Class B: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio

6
communications.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
ACMA compliance
Notice! This is a Class A product. In a domestic environment this
product may cause radio interference in which case the user may
be required to take adequate measures.
Canada
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme
NMB-0330 du Canada.
Certification
N4131
European Union directives
12004/108/EC (EMC directive): Hereby, UTC Fire & Security
declares that this device is in compliance with the essential
requirements and other relevant provisions of Directive
2004/108/EC.
2002/96/EC (WEEE directive): Products marked
with this symbol cannot be disposed of as
unsorted municipal waste in the European
Union. For proper recycling, return this product
to your local supplier upon the purchase of
equivalent new equipment, or dispose of it at
designated collection points. For more
information see: www.recyclethis.info.

7

8