INTEZZE ALPHA User manual

USER MANUAL
Návod k obsluze
ALPHA
IN-EAR HEADPHONES

EN
Introduction
Our passion & your joy
Only together we are INTEZZE
We design all our models to serve reliably for several years, but sometimes
something can go wrong. Therefore, we recommend that you take a few minutes
to read the following pages, where you will learn, among other things, how to
prevent faults and how to proceed when replacing some parts.
Using the in-ear headphones
Before the first use, you must connect both in-ear headphones with the
detachable cable. You will find the exact description in the following chapter.
Before each use of the in-ear headphones:
We recommend lowering the volume of the connected device before connecting
the in-ear headphones. This saves the in-ear headphones and your ears from
high volume shock.

EN
Detachable cable
The connectors connecting the in-ear headphones to the cable should be
handled gently. They are not designed for frequent disconnection and
connection. We recommend only disconnecting the cables when replacing the
cable with a new/different piece.
When disconnecting/connecting the cable, make sure that the L (left) and R
(right) in-ear headphones are properly connected to the corresponding L and R
connectors on the cable. Also pay attention to the correct polarity of the pins.
The cable must always point backwards behind the ear (see next chapter).
If you decide to fine-tune the in-ear headphone sound with your own cable,
always make sure in advance that its in-ear headphone jacks are compatible.
Never use excessive force when connecting the cable!

EN
How to properly connect and disconnect the cable:
1) First, make sure you are connecting the left connector to the left in-ear
headphone and the right connector to the right in-ear headphone.
2) The correct cable routing is behind the ear on both in-ear headphones. You
can also determine the correct polarity of the pins as shown at the top left.
3) Align both pins of the connector exactly against the holes in the in-ear
headphone and push the connector into place. The connector should be
inserted correctly as far as it will go.
4) When disconnecting, always hold the connector as close to the in-ear
headphones as possible and pull in the direction of the pins to disconnect
the connector. Do not wiggle or twist!

EN
Fitting the in-ear headphones into your ears
1) First, identify the left and right in-ear headphone according to the markings
on the back.
2) Then lightly push one of the in-ear headphones into the correct ear so that
the cable points in front of the ear (middle picture).
3) With the other hand, slide the cable loop behind the ear.
4) With one finger, gently push the in-ear headphone into your ear while the
other fingers rotate the in-ear headphone back.
5) When rotated correctly, the in-ear headphone fits well in your ear and its
cable runs diagonally forward and up. Finally, you can try pulling the cable
lightly to make sure that the in-ear headphone is properly fixed in your ear.