IRiver MPlayer User manual

User Guide

CONTENTS
Components 4
Locating the Controls 5
Installing iriver plus 3 6



Chapter 1
Getting Started
Music 19
Chapter 3
Using the Mplayer
Charging the Battery 9
Turning on / off the Player 10
Playing Music Files 11
Connecting Products 12




Chapter 2
Basic Operations
Using iriver plus 3 25
Copyrights / Certication /
Trademarks / Limited Liability 29
Safety Instructions 30
Troubleshooting 32




Chapter 4
Other Information

CONTENTS
Chapter 1
Getting Started
Components 4
Locating the Controls 5
Installing iriver plus 3 6

4
Chapter1 Getting Started
Components Components are subject to change without notice and may vary from images shown.
Mplayer Earphones
Quick Start Guide & Warranty Card Installation CD USB Cable

5
Chapter1 Getting Started
Locating the Controls
Necklace Connection Loop
Earphones Jack
LED
USB Jack
POWER Button
RESET Button

6
Chapter1 Getting Started
1. Insert the installation CD to your PC to display
the installation process screen.
2. Click [Install] and complete the installation process
following the on-screen instructions.
Note
Minimum requirements for using iriver plus 3
Intel® Pentium®ll 233MHz or higher processor speed Windows 2000/XP 64MB or above memory
30MB or above hard disk space 16bit enabled speaker and sound card
Microsoft Internet Explorer version 6.0 or later SVGA or high resolution monitor (1024x768 resolution or higher)
For more information on using iriver plus 3, refer to page 23~26.
Installing iriver plus 3 iriver plus 3 is an integrated software that efciently manages music les.
iriver plus 3 gives you freedom to transfer music les from PC to the player.

CONTENTS
Chapter 2
Basic Operations
Charging the Battery 9
Turning on / off the Player 10
Playing Music Files 11
Connecting Products
Connecting earphones to the Mplayer 12
Connecting earphones while playing music 12
Connecting necklace 13
Disconnecting extension earphones from main line 13
Connecting the Mplayer to your PC 14
Copying le/folder (Using as a removable disk) 15
Disconnecting the Mplayer from your PC 16

9
1. Press the [ ] button on the product to turn it on.
Note
It is recommended to use provided USB cable only. Otherwise, the device may malfunction.
Check if the Mplayer is connected to a high-power USB 2.0 port. Some low-power USB ports built in some peripheral
devices such as certain keyboards and USD hub without integrated power may not provide enough power to charge.
If the computer is in sleep mode, the Mplayer may not be charged in some computers.
The battery will be 80-percent charged in about 1.5 hour (with red LED), and fully charged within about 2.5 hours (with green LED).
You cannot play music while charging the product.
Chapter2 Basic Operations
Charging the Battery
2. Turn on your PC and connect the Mplayer to it
using the USB cable.