5. Setting up SGZB02I
5.1. Turn On SGZB02I
For power saving, SGZB02I is designed to get into sleeping mode when there is no activity for 2
minutes.To manually turn on SGZB02I, press the Binding Key once.
When SGZB02I is first time used or after resetting →it will try to join the network.
When SGZB02I is in a ZigBee network →it will send out the device data, like IEEE
address/Networkaddress, and the indicator will flash green 5 times. SGZB02I will be activated for 2
minutes.
When SGZB02I was in a ZigBee network, but by any change it is offline →it will start to rejoin
theZigBee network.
5.2. Join the ZigBee Network
After SGZB02I is turned on, it will search for an existing ZigBee network and send a request to join the network
automatically. While SGZB02I is under the coverage from a coordinator or a router whose permit-join feature
isenabled, SGZB02I will be permitted to join the network.
Step1. Enable the permit-join function (valid for 60 seconds) of a coordinator or a router (please refer to
the user manual of the coordinator or the router to enable the permit-join feature).
Step2. Turn on SGZB02I. It will start to search and join the network.
Step3. The indicator will flash green once when it finds out a network to join.
Step4. The indicator will flash green 5 times after it is joined successfully. Otherwise, the indicator will
not flash.
NOTE: After joining the network, SGZB02I will try to enroll in the ZigBee security system. Please keep it
powering on.
5.3. Enroll in the ZigBee Security System
SGZB02I is a Zone device in the ZigBee security system. Right after SGZB02I join the ZigBee network, it will
automatically find out a CIE (Control and Indicating Equipment) device (i.e. ISysmart Z201B) and send a
registration request to the CIE device to enroll in the security system. The enrollment has these 3 situations:
A.
There is no CIE device or no compatible CIE device in the network → the indicator flashes orange
twice.
B.
There is a compatible CIE device in the network, but it is failed to enroll →the indicator flashes
orange 4 times.
C.
The enrollment is completed →the indicator flashes orange 6 times.
NOTE: Users had better NOT enroll multiple Zone devices at the same time to prevent registration failure.
