Jabra STONE User manual

Quick Start
1. CHARGE YOUR HEADSET
Charge both your STONE Headset and STONE Charger using the AC adapter.
Place the headset in the STONE Charger.
Take the AC adapter and plug its charging tip into the socket on the STONE Charger.
Plug the AC adapter into a wall outlet.
While charging, the battery indicator on the STONE Charger shows solid red light.
When the light indicator turns off, the headset and STONE Charger are fully charged (approx. 2 hours).
2. YOUR STONE CHARGER
When on the move, place your STONE Headset in the STONE Charger and it will charge wirelessly.
When the STONE Headset is placed in the STONE Charger a small light indicator lets you know your battery
level.
Single green flash: Enough battery to charge headset 1 full time or more.
Single red flash: STONE Charger needs to be charged.

3. TURN YOUR HEADSET
ONPush the headset out of the STONE Charger by pressing on the backside.
Battery indicator will light up for 4 seconds showing that the headset is on.
Green: The battery is ok (between 10 min. and 2 hours left).
Red: Less than 10 min. remaining talk time.
4. TURN YOUR HEADSET OFF
Insert the headset into the STONE Charger.
The headset is now turned off, but ready to take a call.
Please note: It is possible to turn off the headset manually without using the STONE Charger. Press
Answer/End button for 4-5 seconds to turn it on/off.
5. PAIR YOUR HEADSET WITH YOUR MOBILE PHONE
The first time you clip the headset out of the STONE Charger, it automatically enters pairing mode
(showing flashing blue light on the Jabra StatusDisplay™).
For later pairing:
Turn your Headset off by manually pressing the Answer/End button for 4-5 seconds. Turn the headset on
again by pressing the Answer/End button until the StatusDisplay™ flashes blue.

Set your Bluetooth® phone to discover the Jabra STONE. Follow your phone's instruction guide. This
usually involves going to a "setup", "connect" or "Bluetooth®" menu on your phone and selecting the
option to discover or add a Bluetooth® device.
Your phone will find the Jabra STONE. Your phone then asks if you want to pair with it. Accept by pressing
"yes" or "ok" on the phone and confirm with the passkey or PIN = 0000 (four zeros) if prompted.
Your phone will confirm when pairing is complete. In case of unsuccessful pairing, repeat the steps.
When your STONE Headset shows a solid blue light for 4 seconds, pairing is successful!
6. ACCEPTING A CALL ON YOUR HEADSET
The headset is ready to take calls when clipped into the STONE Charger.
Push the headset out of the STONE Charger, place it on your right ear and tap the Answer/End button.
7. ENDING A CALL ON YOUR HEADSET
Tap the Answer/End button on your headset to end an active call.

8. ADJUST THE VOLUME
Slide your finger up or down the front of the STONE Headset to adjust the volume.
9. CHECK YOUR STATUS
The StatusDisplay™ lets you check your battery level and Bluetooth® connectivity at a glance.
Simply insert your headset into the STONE Charger and take it out again to check your status.
Solid blue = paired.
Green light = battery ok.
Red light = less than 10 min. talk time.
10. LISTEN TO MUSIC
Play music*
Music is controlled on the mobile phone.
Answer a call while playing music*

When listening to music and receiving a call, the music will pause and you will hear your ringtone.
* Phone dependent (supports A2DP)
11. WEARING STYLES
The Jabra STONE tucks behind your ear for discreet comfort.
Wear your Jabra STONE Headset on your right ear.