ENGLISH OPERATION MANUAL
JB SYSTEMS 1/3 ISX-series
FEATURES
yPerfect for Permanent installations in pubs, clubs, restaurants, …
yVery compact design
yOnly one power amplifier needed (ISX-15S has built-in crossover)
yISX-15S: High power dual voice coil 15” Woofer
yFlexible setup, each ISX-15S supports:
oUp to 8x ISX-5 cabinets.
oUp to 4x ISX-10 cabinets.
yISX-5 and ISX-10 can be used as full range cabinets.
SAFETY PRECAUTIONS
yThe ISX-series can easily reproduce sound pressure levels (SPL) sufficient
enough to cause sever and permanent hearing damage. Always protect your
ears when you are exposed to SPL in excess of 85dB!
yBe sure that the power amp is turned off before connecting the speakers.
yAlways mount the speaker cabinets in safe and stable conditions.
yThe woofers and tweeters are not protected against humid and rain. Therefore
these speaker cabinets are intended for indoor use only, use of these products
outdoors, in humid conditions, voids all warranties.
MAINTENANCE
Clean the cabinets with a sponge and some non aggressive soap solution. Don’t use
any chemical solvents as they attack the enclosure! Take care that no water can
enter the enclosures.
CONNECTIONS AND USE
ISX-5 ~ ISX-10 FULL RANGE:
You can use both speaker cabinets as full range units, without the subwoofer. While
ISX-5 has 16Ωimpedance, you can link up to 4 cabinets in parallel to obtain 4Ωload
for your amplifier.
ENGLISH OPERATION MANUAL
JB SYSTEMS 2/3 ISX-series
COMBINED SETUP:
In this setup you only need one amplifier. Both channels of the amplifier are
connected to the ISX-15S. The ISX-5 or ISX-10 cabinets are connected to the
outputs on the ISX-15S subwoofer.
Note: Don’t mix ISX-5 and ISX-10 on the same Subwoofer.
ISX-5:You can connect up to 4 “ISX-5” cabinets to each subwoofer output. This
means a total maximum of 8 cabinets. (see drawings)
OR
ISX-10:You can connect up to 2 “ISX-10” cabinets to each subwoofer output. This
means a total maximum of 4 cabinets. (see drawings)
OR
HOME CINEMA SETUP:
In this setup your
surround sound amplifier
has several separate
speaker outputs (front,
rear, central, etc.). You
can connect the ISX-5
and/or ISX-10 cabinets
to these outputs as you
like. The subwoofer
needs to be connected to
a separate amplifier,
connected to the “sub
out” from your surround sound amplifier. In this setup the ISX-15S subwoofer will act
as a mono subwoofer. This means it must be connected in a different way: don’t use
the outputs and connect the subwoofer as shown on the drawing.
Note: The ISX-cabinets are not electromagnetically shielded. Don’t put a cabinet near your TV!
