Juniper CV-3 User manual

CV-3
4-Person
Meeting Pod
General Installation Guide

ii
4-PERSON MEETING POD
2 | Insert Steel Dowels into Joint Holes
Line up steel dowels so that they are flush with joint holes on adjacent panel.
Push against outer walls of pod until panels are flushed.
1 | Secure Connecting Steel Dowels to Panels
Insert connecting steel dowel plate into marking hole and insert four 3/4” screws
through flat plate to secure. Repeat step for all 4 steel dowels.

iii
4-PERSON MEETING POD
3 | Secure Panels
Adjust panel bracket, attached to bottom of panel, so open end fits around
stand-alone bolt on bottom of adjacent panel.
4 | Connect Main Power
Assemble connector joint by securing male and female halves together and secure with
connector clips on top and bottom of assembly.

iv
4-PERSON MEETING POD
5| Secure Connecting Steel Dowels to Top Panel
Insert connecting steel dowel plate into marking hole on bottom side of top panel and
insert four 3/4” screws through flat plate to secure. Repeat step for all 10 steel dowels.
6 | Connect Power to Top Panel
Assemble connector joint by securing male and female halves together and secure
with connector clips on top and bottom of assembly. Once connected, tuck completed
assembly into slot at top of side panel.

v
4-PERSON MEETING POD
8 | Place Seats Inside Pod
Tilt seat at a 45 degree angle. Slide into pod while tilting seat back so seat sits flat
on floor. Repeat for other side.
7 | Secure Top Panel
Line up steel dowels so they are flush with joint holes on adjacent panel. Push against
outer walls of pod until panels are flushed.

vi
4-PERSON MEETING POD
9| Secure Leg to Table
Secure 4 screws through pre-drilled table base holes and into bottom of table surface.

vii
END OF 4-PERSON MEETING POD SECTION
10 | Secure Table to Back Panel of Pod
Secure table bracket to back panel using 3 bolts. Once secure, place table over bracket,
lining up pre-drilled holes on bottom of table surface and secure.

1-866-999-0955 | hello@juniperoffice.com | juniperoffice.com
© 2023 Juniper Office | Version 23.0.0