Juniper JOT Desk BSW User manual

Watch Entire
Install Video
BSW
JOT Desk
Fixed-Height Workstation
Includes Add-Ons: A1 | A2 | A3 | A4
General Installation Guide

TABLE OF CONTENTS
Edition Code
BSW :: Workstation..................................................................................... 1
Add-ons
A1 :: Surface-Mount Cable Management Tray ......................7
A2 :: Modesty Panel................................................................................. 11
A3 :: Laminate Inset End Panels..................................................... 15
A4 :: Steel Inset End Panels.............................................................. 23

Workstation
Overview
JOT Fixed-Height Workstation
All parts listed are for a single workstation; additional
parts will be needed for additional workstations.
1
Scan to
Watch Section

2
WORKSTATION
Code Qty. Description
GB3072 1Surface
BB3
1Extra Long Beam
2Lock Plate
2Cap Screw
1Locking Screw and Lever
BL30
230” End Leg
12 Wood Screws
BASB72
142” Support Bar*
10 Wood Screws
Parts List
*Part will be added to surfaces 72” and longer

3
WORKSTATION
1 | Join End Legs with Beam
Insert beam tabs into leg brackets. Guide beam tabs into bracket
holes, ensuring that there is not a gap between the beam and legs.
Using a rubber mallet, hammer the beam to lock in place.
2 | Bolt Down Beam-to-Leg Lock Plate
Note: The beam lock plates will not fit if there is a gap between
the beam and the leg.
Scan to
Watch Step
Scan to
Watch Step

4
WORKSTATION
3 | Measure and Adjust Beam Width
Measure from end leg to end leg until you find the approximate width of
the work surface. Insert the screw through the overlapping beam slots and
into the locking screw and lever. Slightly tighten the screw. DO NOT fully
tighten. Insert beam grommet covers.
4 | Secure the Surface
Position the surface on the desk frame. Align the outer sides of the surface
flush and parallel with the outer sides of the end legs, adjust if not flushed.
Insert wood screws into the leg brackets and secure to the underside of
the surface.
Align Flush
Align Flush
Scan to
Watch Step
Scan to
Watch Step

5
WORKSTATION
5 | Secure Beam
Tighten beam locks.
Optional | Install Support Bar
If working with a surface 72” or longer, use 10 wood screws to install
support bar under the surface.
Scan to
Watch Step
Scan to
Watch Step

6
END OF WORKSTATION SECTION

A1: Surface-Mount Cable
Management Tray
Overview
JOT Fixed-Height Workstation
If workstations have power, refer to BL-8 JOT power guide.
7
Scan to
Watch Section