JWA EDINBURGH 69110 User manual

1
Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please refer to your receipt
ASSEMBLY INSTRUCTION
EDINBURGH
69110/69113
SINGLE BED

PRE-ASSEMBLY PREPARATION
2
Before you start:
1.Choose aclean, level, spacious assembly area.Avoid hard surfaces that may damage the
product
2.Take care when lifting.Product should be assembled as near as possible to the point of
use
3.Ensure that you have all required contents for complete assembly
4.Always read the assembly instructions carefully before beginning assembly.
5.Keep all hardware parts and packaging out of reach of small children.
6.Do not over tighten the screws and bolts as this may damage the threads
7.Assembly is to be carried out by acompetent adult(s) ONLY
8.During assembly, children should be kept away from the product due to possible risk to
injury.
9.Do not use this item if any components are missing or damaged.
10.Please keep the instructions for future reference.
Allow 20 min For 2person

3
PARTS LIST
1
Headboard x 1pc
4
Cross
Bar x 1pc
2
Footboard x 1pc
5
Slat (905mm) x 13pcs
3
Siderail
x 2pcs
6
End Cap x 26pcs

4
STEP 1:
•Prepare a protected surface with a blanket or cardboard.
•Connect a side rail(3) to the headboard and footboard. Secure
with 2x bolt(A) per corner. Fasten with allen key(C).
•Repeat for the other side rail.

5
STEP 2:
•Attach the cross bars(4) to the side rail(3), as shown below. Use
2x bolt(B). Fasten with allen key(C).

6
STEP 3:
•Attach an end cap(6) onto every slat, 2 per slat(5).
•Attach the slat to the bed as shown below. Push the caps into
the holes.

7
7
Assembly Is Complete

8
PRODUCT CARE:
FURNITURE / BED
1. When assembling your furniture / bed please ensure that you have
checked the contents for all relevant parts.
2. When tightening bolts make sure that they are fully tightened but not
forced.
3. When moving your fully assembled bed you must first remove the
mattress and lift the frame into position, take care when lifting and
always have two people handling the bed. PLEASE DO NOT DRAG THE
BED as this will cause damage to the rail.
4. It is advisable to use approved cleaning products when cleaning the
furniture and bed frame as certain chemical based cleaners could have
an adverse effect on the bed finish.
8