JWA FRIEDMAN 74336 User manual

Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please refer to your receipt
ASSEMBLY INSTRUCTION
74336
QUEEN BED
FRIEDMAN
1
2250mm 1730mm
1150mm

PRE-ASSEMBLY PREPARATION
Before you start:
1.Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the
product
2.Take care when lifting. Product should be assembled as near as possible to the point of
use
3.Ensure that you have all required contents for complete assembly
4.Always read the assembly instructions carefully before beginning assembly.
5.Keep all hardware parts and packaging out of reach of small children.
6.Do not over tighten the screws and bolts as this may damage the threads
7.Assembly is to be carried out by a competent adult(s) ONLY
8.During assembly, children should be kept away from the product due to possible risk to
injury.
9.Do not use this item if any components are missing or damaged.
10.Please keep the instructions for future reference.
Allow 30 min For 2 person Additional tools
required
2

3
PARTS LIST

STEP 1:
•Prepare a protected surface with a blanket or cardboard.
•Attach the 4x feet(9) to the headboard(1) and footboard(2), as
shown below. And tighten clockwise.
STEP 2:
•Connect the siderail(3) to the headboard(1) and footboard(2) .
Secure with 2x bolt(A), spring washer(G) and washer(C) per
corner. Fasten with M8 allen key(E).
4

STEP 3:
•Attach 2x centre support leg (7) to the centre rail(6) as shown.
Using 1x bolt (B), washer (C) and fasten with M8 allen key (E).
5
STEP 4:
•Align the centre rail(6) to the headboard and footboard, using 2x
bolt (A),spring washer(G) and washer(C). Fasten with M8 allen
key(E).
•Attach the centre cross rail(8) to the sideral as shown below.
Thread 1x bolt(B),2x washer(C) per side from the top and below,
and lock with Hex nut(D)
•Repeat for the other side rail.

STEP 5:
•Attach the left wing(5),right wing(4) to the headboard(1) use 2x
bolt(B),washer(C) and fully tighten with allen key(E)
•Attach an end cap(12) onto every slat, 1 per slat(10).
•Take 2x slats and cup the non capped end into either side of the
centre cap(11). Form 16x slat pairs.
•Attach the slat pairs to the bed as shown below. Push the caps
into the holes.
6

7
Assembly Is Complete

PRODUCT CARE:
FURNITURE / BED
1. When assembling your furniture / bed please ensure that you have
checked the contents for all relevant parts.
2. When tightening bolts make sure that they are fully tightened but not
forced.
3. When moving your fully assembled bed you must first remove the
mattress and lift the frame into position, take care when lifting and
always have two people handling the bed. PLEASE DO NOT DRAG THE
BED as this will cause damage to the rail.
4. It is advisable to use approved cleaning products when cleaning the
furniture and bed frame as certain chemical based cleaners could have
an adverse effect on the bed finish.
8