JWA HAROLD 716590001 User manual

1
Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please refer to your receipt
ASSEMBLY INSTRUCTION
HAROLD
ITEM CODE 716590001
SOFA TABLE

Allow 15 min For 1 person Additional tool
required
2
PRE-ASSEMBLY PREPARATION
Before you start:
1. Choose a clean, level, spacious assembly area. Avoid hard surfaces that may
damage the product
2. Take care when lifting. Product should be assembled as near as possible to the
point of use
3. Ensure that you have all required contents for complete assembly
4. Always read the assembly instructions carefully before beginning assembly.
5. Keep all hardware parts and packaging out of reach of small children.
6. Do not over tighten the screws and bolts as this may damage the threads
7. Assembly is to be carried out by a competent adult(s) ONLY
8. During assembly, children should be kept away from the product due to possible
risk to injury.
9. Do not use this item if any components are missing or damaged.
10. Please keep the instructions for future reference.

3
PARTS LIST
1 Top Panel x1
2 Side Frame x2
3 Front Frame x2
A
M6X10MM
BOLT 16 PCS
BHEX KEY 1 PC
CPOLISHING CLOTH 1 PC
DFOOT 4 PCS

4
STEP 1:
•Prepare a surface with a protective blanket or cardboard.
•Connect side frame(2) to front frame(3) as shown
•Secure with bolt(A) per connection. Fasten with allen key(B).
•Fasten only until the bolt is tight in the thread, do not fully fasten
for now.
•Screw foot(D) to unit as shown

5
STEP 2:
•Connect top panel(1) to unit as shown.
•Secure with bolt(A) per connection. Fasten with allen key(B).
•Once levelled turn the table back on its side and fasten all the
bolts.

6
ASSEMBLY IS COMPLETE

7
SAFETY BRACKETS
INSTRUCTIONS
1. Attach one Mounting Plate to the wall with the Large Screws. Make sure to attach
the Mounting Plate into a stud. If mounting into brick or masonry you will need to
acquire wall anchors.
2. Attach the second Mounting Plate to the furniture frame with the Short Screws.
3. Move the furniture to its final position. Thread a Wall Strap through the both
Mounting Plates and tighten until snug. Do not over tighten.
4. Make sure that the Mounting Plates are firmly attached to the wall and furniture
and that the Wall Strap is snug.

8
PRODUCT CARE:
If the glass is chipped or broken, stop using the product and consult
place of purchase
WARNING:
•Do not place very hot or cold items directly onto the glass
surface,unless a coaster or placemat are used to prevent the items
from coming into direct contact with the glass
•Do not sit or stand upon the glass surface
•Do not use the glass as a chopping surface
•Do not strike the glass with hard or pointed items
•When cleaning glass panels use a damp cloth or lather with washing
up liquid or soft soap if necessary. Do not use any cleaning substances
that contain obrasive properties,as these could scratch or damage the
glass.