JWA MORDEN 71238 User manual

1
Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please refer to your receipt
ASSEMBLY INSTRUCTION
MORDEN
ITEM CODE 71238
BEDSIDE

PRE-ASSEMBLY PREPARATION
Before you start:
1.Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the
product
2.Take care when lifting. Product should be assembled as near as possible to the point of
use
3.Ensure that you have all required contents for complete assembly
4.Always read the assembly instructions carefully before beginning assembly.
5.Keep all hardware parts and packaging out of reach of small children.
6.Do not over tighten the screws and bolts as this may damage the threads
2
Allow 15 min For 1 person Additional tools required

3
SAFETY BRACKETS
INSTRUCTIONS
1. Attach one Mounting Plate to the wall with the Large Screws. Make sure to
attach the Mounting Plate into a stud. If mounting into brick or masonry you
will need to acquire wall anchors.
2. Attach the second Mounting Plate to the furniture frame with the Short
Screws.
3. Move the furniture to its final position. Thread a Wall Strap through the both
Mounting Plates and tighten until snug. Do not over tighten.
4. Make sure that the Mounting Plates are firmly attached to the wall and
furniture and that the Wall Strap is snug.

4
To protect your furniture, we suggest the following:
•Avoid placing your furniture in direct sunlight.
•Do not place furniture directly under windows.
•Do not place sharp materials (knife, fork, etc.) directly onto
your furniture as sharp material may scrape and damage the
finish.
•Do not place material with high temperature directly onto the
surface of your furniture.
•Clean up spills quickly. Water left over a prolonged period of
time may cause damage. Alcohol, perfume, nail polishes,
aftershave and some medication may cause severe finish
damage if not cleaned immediately.
•Use a clean, soft, dry, lint free absorbent cloth to clean your
furniture. Do not use any detergent as they may contain
ingredients that may react and damage the finish.
NOTE: If the above care advise is not adhered to your product
warranty may become void

5
Item Code: 71238
Product Name: MORDEN Bedside
PRODUCT CARE:
As our timber is supplied from sustainable forests there will be natural variations in
surface texture and grain like knots, mineral streaks and sap runs that may affect the
finish. These differences in character are not defects, but distinctions that make each
piece of furniture unique
Our furniture is built to last. Following these steps for basic care should protect your
investment for years to come
。Dust frequently with a clean damp lint-free cloth. This will help remove abrasive
build up which can damage a finish over time. Do not use any detergent as they may
contain ingredients that may react and damage the finish.
。Do not place hot objects on any furniture surface. Always use a hot plate or
placemat. Laminate and lacquer finishes on table tops provide added scratch and heat
resistance to our furniture, but they can still be damaged without proper care
。Avoid exposing your furniture to strong sunlight, heat outlet, open windows or
dampness. Prolonged exposure to direct sunlight can fade the finish of your furniture,
while extreme temperature and humidity changes can cause cracking or splitting
。Do not expose your furniture to any liquids. Never allow water to sit on your
furniture. Alcohol, nail polish, perfume, aftershave and some medication are also
dangerous as they will dissolve the lacquer finish on contact and may require
professional repairs
。Do not allow plastic to come in direct contact with your furniture. Chemicals in the
plastic of placemats etc. may soften and mark the finish if left in contact with the
furniture for a period of time
。Do not place sharp materials (knife, fork, etc.) directly onto your furniture as sharp
material may scrape and damage the finish.
Made In: Malaysia
Imported By: JWA Furniture Pty Ltd
Brisbane, Qld, Australia