JWA AZALEA 68216 User manual

1
Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please refer to your receipt
ASSEMBLY INSTRUCTION
AZALEA
ITEM CODE:68216
Outdoor Lounge Chair

Before you start:
1.Choose a clean, level, spacious assembly area. Avoid hard surfaces that may
damage the product
2.Take care when lifting. Product should be assembled as near as possible to the
point of use
3.Ensure that you have all required contents for complete assembly
4.Always read the assembly instructions carefully before beginning assembly.
5.Keep all hardware parts and packaging out of reach of small children.
6.Do not over tighten the screws and bolts as this may damage the threads
7.Assembly is to be carried out by a competent adult(s) ONLY
8.During assembly, children should be kept away from the product due to possible
risk to injury.
9.Do not use this item if any components are missing or damaged.
10. Please keep the instructions for future reference.
2
PRE-ASSEMBLY PREPARATION
Allow 30 min For 2 person

3
PARTS LIST

4
You will need
Step 1
•Prepare a floor or benchtop with a protective blanket or
carboard.
•Prepare 4 bolt sets. Thread bolt(B) through Washer(C).
•Connect Left Arm(2) to the Seat(3), as shown below.
•Secure with 2x bolt sets. Use Allen Key(D).
•Tighten only until the bolt is a little firm in the thread, do not
fasten completely.
•Repeat for the Right Arm(1).

5
You will need
Step 2
•Prepare 4 bolt sets. Thread bolt(B) through Washer(C).
•With the aide of a 2nd person flip the chair over.
•Connect the backrest(4) to the seat arms, as shown below. NB
the braces are on the top side.
•Secure with 4x bolt sets. Use Allen Key(D).
•Tighten only until the bolt is a little firm in the thread, do not
fasten completely.

6
You will need
Step 3
•Prepare 4 bolt sets. Thread bolt(B) through Washer(C).
•Connect the fixed link(5) to the seat arms, as shown below.
•Secure with 2x bolt sets. On each arm. Use Allen Key(D).
•Tighten only until the bolt is a little firm in the thread, do not
fasten completely.

7
ASSEMBLY IS COMPLETE
Step 4
•Stand the chair up the right way.
•Push down on the chair until it levels out. Do not lean beyond
your own balance.
•Once level, turn the table back over, fully fasten all the bolts
with Allen Key(D).
•Do not over tighten, this may damage the product.

8