Kanomax 3888 User manual

●
●
●
●
●
●
●
01001/17.06
Quick Start Guide
For detail description, please refer to the user manual
Handheld Particle Counter Model 3888 and 3889
Include
Main unit Li-ion battery x 2 (installed in the unit) Inlet protective cap
CD-ROM: USB driver, Remote software, User manual
Zero lter with tubing AC adapterUSB cable
Functions
DC jack
Supplies power with the
provided AC adaptor
Inlet
USB port (for PC)
USB port (for Printer & USB memory)
Inlet protective cap
2.83L/min suction volume
Outer diameter 6.4mm
Remove cap while the unit is operating
Connects with your PC by using
the USB cable
Connects with the printer by using the USB cable
Allows you to copy the measurement
results to the USB memory
Change chart types
Switches the chart types:
Bar →Circle →Table ∑
Threaded tripod mount
Attaches instrument to the tripod
Note: Please do not cover or insert anything into
the threaded exhaust port on back of the instrument
Start
Stop
Starts a measurement
Stops a measurement
Power/Home button
Turns the power ON/OFF
To return to the Main screen in operation
General setting
Measurement setting
Preset
Opens the menus to set the unit, calendar, data, sound,
language and to display instrument information
Opens the menu to set the mode, alarm, save, remote
and temperature/humidity
Opens the menu to set or select up to 18 Presets
History
Error
Views the historical data or measurements
Tap the Error key to display an error description
Dierential Δ
Opens the Dierential Δ display on the Main screen
Cumulative Σ
Opens the Cumulative ∑ display on the Main screen
www.calcert.com [email protected]1.888.610.7664 0
5
10
15
20
25
30

1 2 3
Make sure
ow direction
on lter
Zerofilter
Input with
ten keyboard
1
1 0
Tubing
①
②
Select measurement mode Set up location
and sampling time Start measurement
Purging
Measurement
Prior to using the instrument in a clean environment such as cleanrooms, it is recommended to purge the
instrument with the provided zero count lter.
Attach the provided zero count lter to the inlet
Turn the power on and press the Start button.
Perform a continuous measurement for approximately
15 minutes until the measuring count value is suitable
for 10 seconds or more.
After measurement, remove the zero count lter from the inlet
General Setting Select on the Main screen to set the unit, calendar, data, language, and sound
Language
Sound
Information
Selects a language from English, Japanese, Chinese, Spanish
Sets the operation sound ON/OFF
Displays the instrument information
Latest calibration date and rmware version
Unit
Calendar
Data
Select one of the following 3 options of units to reect to the
readings displayed on the Main screen and Measurement results.
Conrms the information and perform operation on the
entire measured data
Set the date and time
Measurementmodes Location
Samplingtime
Sets measurement locations by number
Sets the sampling time of 1 cycle
Ranges: from 1 to 99
Ranges: from 6 sec to 99 min 59 sec
①
②
Go to main screen by
pressing Home button
Press start button to start
measurement
* Measurement starts after
10 seconds warm up time
Repeat
Repeats the measurement of congured sampling time and cycle
Single
Performs a measurement of set sampling time only once
Continuous
Calculation
ISO
GB
Continues a measurement until pressing the Stop button
Calculates the average, standard deviation, maximum, and minimum after measurements
Performs measurements in accordance with ISO 14644
Performs measurements in accordance with Chinese National Standard
2
1
3
www.calcert.com [email protected]1.888.610.7664 0
5
10
15
20
25
30