
handset a minimum of 1.0cm fr
FCC Warning:
Any Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user isencouraged to
try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and
receiver.
—Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician
for help.
Specific Absorption Rate (SAR) information-
SAR tests are conducted using standard operating positions
accepted by the FCC with the phone transmitting at its
highest certified power level in all tested frequency bands,
although the SAR is determined at the highest certified power
level, the actual SAR level of the phone while operating can
be well below the maximum value. Before a new model
phone is a available for sale to the public, it must be tested
and certified to the FCC that it does not exceed the exposure
limit established by the FCC, tests for each phone are
performed in positions and locations as required by the FCC.
For body worn operation, this model phone has been tested
and meets the FCC RF exposure guidelines when used with
an accessory designated for this product or when used with
an accessory that contains no metal and that positions the
om the body. Non-compliance
with the above restrictions may result in violation of RF
exposure guidelines