kenall Topdek TPD Series User manual

www.kenall.com |P: 800-4-Kenall |F: 262-891-9701 |10200 55th Street Kenosha, Wisconsin 53144, USA
This product complies with the Buy American Act: manufactured in the United States with more than 50% of the component cost of US origin. It may be covered by patents
found at www.kenall.com/patents.Content of specication sheets is subject to change; please consult www.kenall.com for current product details. ©2019 Kenall Mfg.Co.
1
INSTALLATION INSTRUCTIONS
TPD23_F-4937_091118
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions
should always be followed, including the following:
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE
APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH
THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND
THE HAZARDS INVOLVED. DISCONNECT POWER TO ALL CIRCUITS
BEFORE WIRING FIXTURE. INSTALL IN ACCORDANCE WITH
ALL NATIONAL, STATE, AND LOCAL CODES. DO NOT CONNECT
TO AN UNGROUNDED SUPPLY. READ ALL FIXTURE MARKINGS
AND LABELS TO ENSURE CORRECT INSTALLATION OF FIXTURE.
SUPPLEMENTAL INSTRUCTIONS MAY BE LOCATED ON THE
FIXTURE, IN ADDITION TO THIS INSTRUCTION SHEET, REGARDING
ORIENTATION, OR MOUNTING RESTRICTIONS.
SAVE THESE INSTRUCTIONS
INSTALLATION INSTRUCTIONS
TPD SERIES
Luminaires for Parking Garages & Surface Lots
TOPDEK™ LED
Square Pole Adapter Plate
The adapter plate ships with every unit
and enables TopDek to be used in square
pole installations.
Square Pole AdapterDrilling Template
ROUND POLE MOUNTING SQUARE POLE MOUNTING
23.00
7.70
32.00
6.10
3.20
20.50
18.50
Ø.438
1.8125
(2)
Ø.875
1.50
3.006.00
.875
3.00 Ø
Ø
.438 (2)
1.50
3.00
DRILL HOLES REQUIRED ON
POLE FOR MOUNTING.
Round Pole 'Ready'
TopDek ships ready for round pole
installations.

www.kenall.com |P: 800-4-Kenall |F: 262-891-9701 |10200 55th Street Kenosha, Wisconsin 53144, USA
This product complies with the Buy American Act: manufactured in the United States with more than 50% of the component cost of US origin. It may be covered by patents
found at www.kenall.com/patents.Content of specication sheets is subject to change; please consult www.kenall.com for current product details. ©2019 Kenall Mfg.Co.
2
INSTALLATION INSTRUCTIONS
TPD23_F-4937_091118
1. Remove the lower portion of the housing.
Fasten the upper portion to the pole, using the
square pole adapter plate if necessary. Feed the
appropriate wiring through the center opening.
2. Slip the bottom portion of the housing onto
the hinged lip.
3. Make all wiring connections using wet
location wire nuts (by others).
4. Swing the lower hinged potion of the xture
upward. Secure the lower to the upper portion of
the housing using the captive screws in the lower
housing. Installation is complete.
Square Pole
(Cut away to
show inside)
Square Pole Adapter
(Not needed for round)
Washer ×2
Lock Washer ×2
3/8" Bolt ×2
For warranty information visit www.kenall.com/Resources/Certied-Performance-Warranties
For technical assistance, call 1-800-4KENALL (1-800-453-6255).
WARRANTY
CUSTOMER SERVICE