
before plugging in
●Make sure your electricity supply is
the same as the one shown on the
rear of your handmixer.
Important – UK only
●The wires in the cord are coloured
as follows:
Blue Neutral, Brown Live.
●The appliance must be protected by
a3A approved (BS1362) fuse.
Note:
●For non-rewireable plugs the fuse
cover MUST be refitted when
replacing the fuse. If the fuse cover
is lost then the plug must not be
used until a replacement can be
obtained. The correct fuse cover is
identified by colour and a
replacement may be obtained from
your Kenwood Authorised Repairer
(see Service).
●If a non-rewireable plug is cut off it
must be DESTROYED
IMMEDIATELY. An electric shock
hazard may arise if an unwanted
non-rewireable plug is inadvertently
inserted into a 13A socket outlet.
●This appliance conforms to EC
directive 2004/108/EC on
Electromagnetic Compatibility and
EC regulation no. 1935/2004 of
27/10/2004 on materials intended
for contact with food.
before using your andmixer
for t e first time
●Wash the parts (see 'cleaning').
key
speed switch
tool release button
mixer
beaters
kneaders
spatula
splash guard
mixing bowl
mixer release switch
cord wrap
cradle release switch
cradle
stand
to use your handmixer
●Unwrap the cord from the cord wrap
before use.
1Insert the mixer into the cradle and
push down to locate .
●To remove, press the mixer release
switch whilst lifting the mixer out
of the cradle.
2 Push down the cradle release switch
and swing the mixer upwards on
the stand .
3 Place the ingredients into the mixing
bowl and then place the bowl on to
the stand.
4 Insert the beaters or kneaders into
the mixer – turn until a positive click
is felt .
●If using the mixer with stand, insert
the beater/kneader with the plastic
gear ensuring it aligns with the drive
gear on the cradle.
●If using the mixer without the stand,
the beater/kneader with the plastic
gear must be inserted into the
socket with the metal ring.
●The beaters/kneaders can only be
removed when the speed switch
is in the off “O” position.
5 Attach the splash guard, if desired
. With the cradle raised, slide the
splashguard into the front until fully
located.
6 Steady the stand with one hand and
lower the cradle/mixer with the other.
Do not use t e cradle release
switc .
7 Plug in.
8 Pull the speed switch backwards to
reach the desired speed (the first dot
on the mixer is the slowest speed
setting). Line up the dot on the side
of the speed switch with the
corresponding speed.
●As the mixture thickens, increase the
speed.
●If the machine starts to slow or
labour, increase the speed.
●Move the switch forwards to the
pulse “P” position to operate the
motor at maximum speed. The
motor will operate for as long as the
pulse is held in position.
4