Kimball Footprint Lateral File with Hinged Door... User manual

Assembly Instructions
Footprint® Page 1 of 2
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Service.
Part No. 2066787 Revision B-08
Lateral File with Hinged Door Storage
Tools Required
ILevel
I3⁄8" nutdriver or socket with ratchet
IPhillips screwdriver
Description
These instructions provide the basic information for leveling
the lateral file and adjusting the hinged door (Figure A).
Installation
1. Position lateral file in the desired location.
2. Close hinged doors and all drawers.
3. Remove bottom drawer: Extend the drawer fully; remove
shipping screw from each slide on drawer; disengage
drawer slides by lifting up on the tabs near front of each
slide; and pull drawer forward and upward to remove
(Figure A).
4. Level the unit by using the 3⁄8" nutdriver or socket to adjust
the floor glides in the bottom panel. When unit is level
make sure all glides are snug to the floor (Figure B).
5. Pull bottom drawer slides out and install drawer in reverse
order outlined in step 3. Ensure drawer slides catch under
rear rail hooks (Figure A).
Figure A
Figure B
RearRail
Hook
Remove
Shipping
Screw
Lift Up
and Out
Lift Tab

Assembly Instructions
Footprint® Page 2 of 2
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Service.
Part No. 2066787 Revision B-08
Lateral File with Hinged Door Storage, continued
6. Adjust door alignment as necessary. There should be a
slight gap between the doors and doors should be level
with each other when they are properly aligned.
Doors out of horizontal alignment (Figure D): Turn screw
labeled “A” (Figure C) clockwise to decrease margin or
counterclockwise to increase margin.
Doors out of vertical alignment (Figure E): Loosen screws
labeled “B” (Figure C). Reposition door up or down for
proper alignment. Retighten screws.
Note: Vertical misalignment can also occur is unit is not level.
Doors out of alignment with the side of the overhead
(Figure F): Slightly loosen screw labeled “C” (Figure C).
Reposition door. Retighten screw.
Figure C
Figure D
Figure E
Figure F
End Panel
Door
DoorDoor
DoorDoor
Doorin Open Position Inside Panel
Screw ìA ”
Screw “B”
Screw “C”
Dislodge Tab
Screw “B”
Printed in U.S.A. © 2008 Kimball International, Inc. T 800.482.1818 F 812.482.8300