WARNING:
CAUTION:
OPERATING INSTRUCTION:
1. CONSIDER WORK AREA ENVIRONMENT
DON'T use fan in damp or wet locations. DON'T use fan in
presence of flammable liquids or gases and high temperature.
DON'T restrict air intake. DON'T use fan near window curtains
or unstable areas.
2. DON'T ABUSE CORD
Never pull fan by cord or yank it to disconnect from receptacle.
Keep cord away from heat, oil, and sharp edges.
3. DISCONNECT FANS
Disconnect fan when not in use, before servicing, and when
attaching accessories.
4. INSPECT FOR DAMAGE
Inspect for damage before using fan. Determine before use if it
will operate properly. Check for alignment or binding of the
motor, blades installed firmly on the motor. Make sure the front
fan guard has been fixed to the back one. Inspect cord
periodically for damage. Check the switch by turning fan on and
off while unit is plugged in. If any of the above are found to be
broken or inoperative, return the fan for repair or replacement of
damaged parts.
5. MIND THE CHILDREN
Children are not allowed to approach the fan, stick fingers or any
other objects such as screwdrivers into the fan guards where air
discharges or takes in when the fan is running.
6.REPLACEMENT PARTS
When servicing, use only genuine parts supplied by the
manufacturers to replace the damaged ones. Replacements must
be done by qualified electricians.
1. Make sure the voltage accords with 240v, 50Hz.
2. Check the switch IS IN THE ‘0 POSITION.
3. Hold up the head of the fan to avoid it falling down before
adjusting it upward or downward to a satisfactory position by
loosening and tightening up the changing bolt.
4. Insert the plug into the electric socket.
5. Turn on the switch to 1 , 2 or 3 to choose the speed: 1 low,
2 medium, 3 high, 0 stop.
6. Disconnect the fan with electricity when not in use.
OPERATING INSTRUCTION:
WHEN USING ELECTRIC PRODUCTS, BASIC SAFETY PRECAUTIONS
SHOULD ALWAYS BE FOLLOWED TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK AND PERSONAL INJURY, ETC.
'
MAINTAIN FAN
INSTALLATION:
To keep fan, motor, blades and fan guards clean in a safe way, please follow
the steps below:
A) Unplug fan and loosen the clips on the fan guards before using
dry cloth to keep the fan away from dust.
B) Gently wipe the blades to avoid them being damaged,
resulting poor operation.
C) Ensure all the parts have been fastened after reassembling.
D) Keep fan a trial running for 5 minutes to confirm its normality.
Should anything of the fan be found abnormal after cleaning,
please stop immediately to have it checked and fixed a service agent
Repairs should only be conducted by a qualified technician
GREASE RENEWED
The used grease should be renewed by qualified
after 2000 hours' running.
DIMENSION
.
.
technician
D
SPEC mm
φA830
B~C 1650~2000
D 650
Please refer the assembling diagram to install stand fan
