KMART Parallel Garment Rack User manual

Assembly Instructions
Parallel Garment Rack
Ref Description Illustration Qty
White Lower
Side Stand
2 pcs
E
Ref Description Illustration Qty
IExtendable Post
(with red marker)
2 pcs
H1 pc
OLong Screw
& Nut
4 sets
Screw 4 pcs
P
Spanner 1 pc
Q
Base Rails
Connector
4 pcs
M
Wire Shelf
Front Post
Connector
2 pcs
K
Locking Screw 4 pcs
L
Castor 4 pcsN
Parts Supplied
User Instructions:
•To adjust the garment rack, simply release the locking mechanism located on both vertical
bars. Move the bar to the desired height, and re-lock. Ensure vertical bars are simultaneously
adjusted at all times.
PLEASE NOTE: Failure to follow this instruction will place undue stress on the plastic joints,
and may cause the Plastic components to break.
MAXIMUM WEIGHT LOAD 10KGS evenly distributed over rails.
•
•
Bottom “U” Bar 2 pcs
F
Base Rails 2 pcs
G
Tools Required (not supplied)
• Phillips head screwdriver
• Cushioned hammer
J2 pcs
Back Post
Connector
•
1 pc Back Top
Horizontal Bar
(no marker)
4 pcs
A2 pcs Chrome
Upper Back Post
(with red marker)
B
1 pc Front Top
Horizontal Bar
(no marker)
Longer Bar
C
red marker
Chrome Upper
Front Post
(with red marker)
2 pcs
D
red marker
red marker
AX2 BX1 CX1

Tube I leave
at least 5cm
inside Tube B
Press to lock
extendable
Tube I
Tube A & D
leave at least
5cm inside
Tube E
Clockwise
tightened
1. Connect the base rail connectors (M) to the base rails (G) and bottom U bars (F)
with the long screw and nut (O).
2. Attach the castors (N) to bottom of the base rails until it is securely locked. Insert
the white lower side stands (E) in the bottom U bars and screw (P) in place.
3. Connect the front top horizontal bar (C) to the chrome upper front posts (D) by
using the front post connectors (K). Use a cushioned hammer if necessary.
4. Insert the two chrome upper back posts (A) and the back top horizontal bar (B)
into the back post connectors (J). Place each of the extendable posts (I) into the
horizontal bar.
5. Once you have completed assembling the front and back garment arms, insert
them into the stands of the rack with the red marker facing down first. To lock the
upper posts into position, tighten the locking screws (L) clockwise.
Note: Check that all joints and posts are firmly fixed together.
6. Place the wire shelf (H) onto the bottom U bars of the rack.
7. Whilst adjusting the height or length of the rack, leave at least 5cm inside the
frame as indicated by the red markers.
Care & Use
• Wipe clean with a soft damp cloth. Never use scourers, abrasives or chemical
cleaners.